At sea level, the greatest possible vacuum (most negative gauge pressure) is about
Show answer & solution
Answer: (C) −101.3 kPa
Gauge = absolute − atmospheric; with absolute pressure at least zero, gauge ≥ −101.3 kPa.
Civil Engineering · Hydraulics & Fluid Mechanics
45 questions, each with the answer and a worked solution. Notes on units and constants are at the top.
Practice interactively and track your score →SI units throughout. Take g = 9.81 m/s² and the density of water as 1000 kg/m³ wherever a value is needed.
At sea level, the greatest possible vacuum (most negative gauge pressure) is about
Answer: (C) −101.3 kPa
Gauge = absolute − atmospheric; with absolute pressure at least zero, gauge ≥ −101.3 kPa.
The pressure diagram on a vertical dam face holding water up to its crest is
Answer: (A) triangular, zero at top and maximum at base
p = γh varies linearly with depth, giving a triangular distribution that is zero at the surface.
Water stands 20 m deep against the vertical upstream face of a dam. The hydrostatic force per metre length of the dam is
Answer: (C) 1962 kN/m
F = ½γh² = 0.5 × 9.81 × 20² = 1962 kN/m, acting at h/3 from the base.
For the dam in which water is 20 m deep, the hydrostatic force per metre length is 1962 kN/m. The overturning moment of this force about the base per metre length is
Answer: (D) 13080 kN·m/m
The force acts at h/3 = 6.67 m from the base, so M = 1962 × 20/3 = 13080 kN·m per metre.
A vertical rectangular plate 1 m wide and 3 m high is submerged in water with its top edge 2 m below the free surface. The centre of pressure lies at a depth of
Answer: (C) 3.71 m
h* = h̄ + I_G/(A h̄) = 3.5 + (1 × 3³/12)/(3 × 3.5) = 3.71 m below the free surface; 4.00 m wrongly uses the top-at-surface rule.
A pressure of 1 bar is equal to
Answer: (D) 100 kPa
1 bar = 10⁵ N/m² = 100 kPa.
A vertical circular gate of diameter 2 m has its centre 4 m below the water surface. The hydrostatic force on the gate is
Answer: (D) 123.28 kN
F = γ h̄ A = 9.81 × 4 × (π × 1²) = 123.28 kN.
A vertical rectangular gate 1.5 m high and 1 m wide is hinged at its bottom edge and holds water up to its top edge. The horizontal force needed at the top edge to keep it closed is
Answer: (A) 3.68 kN
F = ½γbh² = 11.04 kN acts at h/3 = 0.5 m from the hinge, so P × 1.5 = 11.04 × 0.5 gives P = 3.68 kN.
Tilting the measuring limb of a single-limb manometer to an angle θ with the horizontal increases its sensitivity because
Answer: (A) the liquid moves a length 1/sinθ times the vertical rise
Vertical rise h = L sinθ, so for small θ a small pressure change produces a large, easily read movement along the tube.
Two plane surfaces of equal area have centroids at the same depth in the same liquid. The total hydrostatic force on them is
Answer: (A) equal, though their centres of pressure may differ
F = γh̄A depends only on centroid depth and area; shape and inclination affect only the centre of pressure.
Uplift pressure acting on the base of a gravity dam
Answer: (C) reduces the net downward force and sliding resistance
Uplift opposes the dam's weight, reducing the effective normal reaction, friction and stability.
A vertical rectangular gate 2 m wide and 3 m high has its top edge 1 m below the water surface. The hydrostatic force on the gate is
Answer: (C) 147.2 kN
F = γ·A·h̄ = 9.81 × (2 × 3) × 2.5 = 147.2 kN (centroid depth 1 + 1.5 = 2.5 m).
In an inverted U-tube manometer connecting two water pipes, the fluid in the upper bend should be
Answer: (D) immiscible with water and lighter than water
A lighter immiscible fluid (air or oil) stays on top of the water columns, and its density enters the pressure-difference equation.
An inclined-tube manometer uses a liquid of specific gravity 0.8, with the tube inclined at 30° to the horizontal. The liquid moves 0.25 m along the tube. The gauge pressure measured is
Answer: (B) 981 Pa
p = γL sinθ = 800 × 9.81 × 0.25 × sin30° = 981 Pa; omitting sinθ would give 1962 Pa.
Sea water of specific gravity 1.03 fills a harbour. What is the gauge pressure at a depth of 12 m?
Answer: (C) 121.25 kPa
p = ρgh = 1030 × 9.81 × 12 = 121.25 kPa (gauge); 117.72 kPa ignores the specific gravity and 222.55 kPa is the absolute value.
For an isothermal atmosphere of ideal gas, the pressure varies with elevation z as
Answer: (B) p = p₀ exp(−gz/RT)
With ρ = p/RT, dp/dz = −pg/RT integrates to an exponential decrease with height.
According to the hydrostatic paradox, the force on the base of vessels having equal base areas and filled to the same height with the same liquid is
Answer: (D) equal for all, whatever the vessel shape
Base pressure is ρgh and force is ρghA, depending only on depth and base area, not on the liquid's weight or vessel shape.
A plane rectangular gate 4 m long (along the incline) and 1.5 m wide is inclined at 60° to the horizontal with its upper edge at the water surface. The hydrostatic force on one face is
Answer: (A) 101.95 kN
h̄ = 2 sin60° = 1.732 m and A = 6 m², so F = γh̄A = 9.81 × 1.732 × 6 = 101.95 kN.
For a curved surface with liquid on its underside, the vertical component of force is
Answer: (B) upward, equal to the weight of imaginary liquid up to the free surface
The imaginary liquid volume extends from the surface to the free-surface level and the force acts upward.
Mercury is preferred as a barometric liquid chiefly because it has
Answer: (D) high density and negligible vapour pressure
High density keeps the column short (about 760 mm) and negligible vapour pressure keeps the space over it a near-perfect vacuum.
The centre of pressure of a submerged horizontal plane surface
Answer: (A) coincides with its centroid
Pressure is uniform over a horizontal surface, so the resultant acts at the centroid.
The vertical component of hydrostatic force on a curved surface acts through
Answer: (A) the centroid of the liquid volume over it
F_V equals the weight of the (real or imaginary) liquid up to the free surface and acts through that volume's centroid.
For a fluid at rest with z measured vertically upward, the governing pressure relation is
Answer: (B) dp/dz = −ρg
In a static fluid, pressure decreases with elevation at the rate ρg.
The absolute pressure at a depth of 5 m in a freshwater lake, with atmospheric pressure of 101.3 kPa, is
Answer: (D) 150.35 kPa
p_abs = p_atm + ρgh = 101.3 + 1000 × 9.81 × 5/1000 = 150.35 kPa.
The second moment of area used in the centre-of-pressure formula for a rectangle of width b and depth d (d vertical) about its centroidal horizontal axis is
Answer: (C) bd³/12
For a rectangle I_G = bd³/12 about the centroidal axis parallel to the width.
A tank holds 2 m of oil (SG 0.8) floating on 3 m of water. The gauge pressure at the bottom of the tank is
Answer: (D) 45.13 kPa
p = γ_o(2) + γ_w(3) = 9.81 × (0.8 × 2 + 3) = 45.13 kPa.
As a vertical plane surface is lowered deeper into a liquid, its centre of pressure
Answer: (B) approaches the centroid
The offset I_G/(A h̄) decreases as h̄ increases, so the centre of pressure moves closer to the centroid.
An inverted U-tube manometer between two water pipes at the same level contains oil of specific gravity 0.8 in its upper bend. The water columns differ by 0.40 m. The pressure difference between the pipes is
Answer: (B) 785 Pa
Δp = (γ_w − γ_o)h = 9810 × (1 − 0.8) × 0.40 = 785 Pa.
To avoid tension at the base of a rectangular-based gravity dam, the resultant force must cut the base within
Answer: (D) the middle third
With eccentricity e ≤ B/6, the base stress stays compressive, which defines the middle-third rule.
For a plane surface inclined at angle θ to the free surface, the vertical depth of the centre of pressure is
Answer: (D) h̄ + I_G sin²θ/(A h̄)
With slant distances, y* = ȳ + I_G/(Aȳ); multiplying by sinθ to get depth gives the sin²θ term.
The resultant hydrostatic force on a submerged circular-arc surface passes through
Answer: (C) the centre of curvature of the arc
Every elemental pressure force is normal to the arc, so every one of them, and their resultant, pass through the centre of the circle.
A U-tube manometer measures the gauge pressure of water in a pipe. Water fills the connecting limb from the pipe centre down to the mercury (SG 13.6) surface, which is 0.15 m below the pipe centre. The mercury surface in the open limb stands 0.30 m above the mercury surface in the connected limb. The gauge pressure at the pipe centre is
Answer: (C) 38.55 kPa
p = γ_m(0.30) − γ_w(0.15) = 9.81 × (13.6 × 0.30 − 0.15) = 38.55 kPa; omitting the water column gives 40.02 kPa.
A vessel has an absolute pressure of 30 kPa inside while the atmospheric pressure is 101.3 kPa. The vacuum (negative gauge) pressure is
Answer: (B) 71.30 kPa
Vacuum pressure = p_atm − p_abs = 101.3 − 30 = 71.3 kPa.
A quadrant gate of radius 2 m and width 3 m has water on its concave side up to the level of the top of the quadrant. The vertical component of the water force on the gate is
Answer: (A) 92.46 kN
F_V = γ × (πr²/4) × b = 9.81 × (π × 2²/4) × 3 = 92.46 kN.
The direction of the resultant hydrostatic force on a submerged plane surface is
Answer: (B) normal to the surface
A static fluid cannot sustain shear, so pressure forces act perpendicular to the surface.
When writing a manometer equation and moving downward through a continuous liquid column, the pressure
Answer: (C) increases by γh
Pressure increases with depth in a static liquid by γ times the vertical height.
A piezometer tube is unsuitable for measuring
Answer: (B) pressures in gases
A piezometer needs a liquid column with a free surface, so it cannot measure gas pressure (or very large pressures).
A mercury (SG 13.6) differential manometer connects two points A and B in a horizontal water pipe, giving a mercury level difference of 0.20 m. The pressure difference p_A − p_B is
Answer: (A) 24.72 kPa
Δp = (γ_m − γ_w)h = 9.81 × (13.6 − 1) × 0.20 = 24.72 kPa.
The horizontal component of hydrostatic force on a curved surface acts through
Answer: (D) the centre of pressure of its vertical projection
The horizontal component equals the force on the vertical projection and acts at that projection's centre of pressure.
A piezometer connected to a pipe carrying oil of specific gravity 0.85 is used to measure a gauge pressure of 24.5 kPa. The oil rises in the tube to a height of
Answer: (B) 2.94 m
h = p/(ρg) = 24500/(850 × 9.81) = 2.94 m; dividing by 1000 kg/m³ (water) gives only 2.50 m.
In a hydraulic press, the small and large pistons have diameters of 50 mm and 300 mm. A force of 400 N on the small piston can support a load of
Answer: (B) 14.4 kN
By Pascal's law F₂ = F₁(D₂/D₁)² = 400 × 6² = 14400 N = 14.4 kN; using the diameter ratio alone gives 2.4 kN.
In a closed tank with gauge air pressure p₀ over the liquid, the equivalent free surface lies
Answer: (D) p₀/γ higher than the actual liquid surface
A pressure p₀ is equivalent to an extra liquid head p₀/γ, which locates the imaginary free surface.
A micro-manometer using two immiscible liquids is highly sensitive when the two liquids have
Answer: (C) nearly equal densities
Reading ∝ Δp/[(ρ₁ − ρ₂)g], so a small density difference magnifies the reading.
A vertical rectangular gate 2 m wide holds water 3 m deep, with its top edge at the free surface. The total hydrostatic force on the gate is
Answer: (C) 88.29 kN
F = ½γbh² = 0.5 × 9.81 × 2 × 3² = 88.29 kN.
In terms of absolute pressure, a perfect vacuum corresponds to
Answer: (A) zero absolute pressure
A perfect vacuum has no molecular pressure, so p_abs = 0 (gauge pressure −101.3 kPa at sea level).