Engineering, Management, Agriculture and Veterinary MCQs are now live. FPSC, PPSC, EPE, IELTS & GRE coming soon.

Electronics: Operational Amplifiers

Electrical Engineering · Electronics

27 questions, each with the answer and a worked solution.

Practice interactively and track your score →
Question 1

What is the open-loop voltage gain of an ideal op-amp?

  1. Infinite
  2. One
  3. Equal to Rf/Rin
  4. Zero
Show answer & solution

Answer: (A) Infinite

Practical op-amps have gains of about 10⁵ or more.

Question 2

What is the input impedance of an ideal op-amp?

  1. One ohm
  2. Equal to the load
  3. Infinite
  4. Zero
Show answer & solution

Answer: (C) Infinite

No current flows into the ideal op-amp inputs.

Question 3

What is the output impedance of an ideal op-amp?

  1. One kilo-ohm
  2. Infinite
  3. Equal to the input impedance
  4. Zero
Show answer & solution

Answer: (D) Zero

The output voltage is independent of load.

Question 4

What is the virtual short concept in op-amp circuits with negative feedback?

  1. The inputs are physically shorted
  2. The voltages at the two input terminals are practically equal
  3. The output is shorted
  4. The supply is shorted
Show answer & solution

Answer: (B) The voltages at the two input terminals are practically equal

It follows from very high open-loop gain.

Question 5

What is the voltage gain of an inverting amplifier with feedback resistor Rf and input resistor Rin?

  1. −Rf/Rin
  2. Rin/Rf
  3. −Rin/Rf
  4. 1 + Rf/Rin
Show answer & solution

Answer: (A) −Rf/Rin

The negative sign shows phase inversion.

Question 6

At which op-amp terminal are both the input signal and the feedback applied in an inverting amplifier?

  1. The non-inverting terminal
  2. The inverting terminal
  3. The supply terminal
  4. The output terminal
Show answer & solution

Answer: (B) The inverting terminal

The non-inverting terminal is grounded.

Question 7

What is the voltage gain of an inverting amplifier with Rf = 100 kΩ and Rin = 10 kΩ?

  1. −10
  2. −0.1
  3. 10
  4. 11
Show answer & solution

Answer: (A) −10

Gain = −100/10 = −10.

Question 8

What is the voltage gain of a non-inverting amplifier with feedback resistor Rf and ground resistor R1?

  1. −Rf/R1
  2. R1/Rf
  3. 1 + Rf/R1
  4. Rf/R1
Show answer & solution

Answer: (C) 1 + Rf/R1

The output is in phase with the input.

Question 9

What is the gain of a non-inverting amplifier with Rf = 90 kΩ and R1 = 10 kΩ?

  1. −9
  2. 0.9
  3. 9
  4. 10
Show answer & solution

Answer: (D) 10

Gain = 1 + 90/10 = 10.

Question 10

What is the voltage gain of an op-amp voltage follower?

  1. −1
  2. 1
  3. Infinite
  4. 0
Show answer & solution

Answer: (B) 1

It is used as a buffer with high input and low output impedance.

Question 11

What does a summing amplifier do?

  1. Multiplies two signals
  2. Compares two voltages
  3. Integrates a signal
  4. Produces an output proportional to the weighted sum of several inputs
Show answer & solution

Answer: (D) Produces an output proportional to the weighted sum of several inputs

It is used in audio mixers and DAC circuits.

Question 12

Which component is placed in the feedback path of an op-amp integrator?

  1. A resistor only
  2. An inductor
  3. A capacitor
  4. A diode
Show answer & solution

Answer: (C) A capacitor

The output is proportional to the integral of the input.

Question 13

Which component is placed at the input of an op-amp differentiator?

  1. An inductor
  2. A diode
  3. A capacitor
  4. A resistor only
Show answer & solution

Answer: (C) A capacitor

The output is proportional to the rate of change of input.

Question 14

How does an op-amp operate as a comparator?

  1. With heavy negative feedback
  2. As a voltage follower
  3. As an integrator
  4. In open loop, so the output swings to saturation depending on which input is higher
Show answer & solution

Answer: (D) In open loop, so the output swings to saturation depending on which input is higher

Comparators detect thresholds.

Question 15

What is the main feature of a Schmitt trigger?

  1. Hysteresis provided by positive feedback, giving clean switching with noisy inputs
  2. Linear amplification
  3. Negative feedback only
  4. No feedback
Show answer & solution

Answer: (A) Hysteresis provided by positive feedback, giving clean switching with noisy inputs

It has two different switching thresholds.

Question 16

What is the slew rate of an op-amp?

  1. The open-loop gain
  2. The maximum rate of change of output voltage, usually in V/µs
  3. The bandwidth at unity gain
  4. The input offset voltage
Show answer & solution

Answer: (B) The maximum rate of change of output voltage, usually in V/µs

Slew rate limits large-signal high-frequency response.

Question 17

What is the typical slew rate of the general-purpose 741 op-amp?

  1. About 0.001 V/µs
  2. About 0.5 V/µs
  3. About 50 V/µs
  4. About 500 V/µs
Show answer & solution

Answer: (B) About 0.5 V/µs

Faster op-amps have slew rates of tens or hundreds of V/µs.

Question 18

What is input offset voltage of an op-amp?

  1. The supply voltage
  2. The common-mode voltage
  3. The small DC voltage that must be applied between inputs to make the output zero
  4. The output voltage at saturation
Show answer & solution

Answer: (C) The small DC voltage that must be applied between inputs to make the output zero

It arises from mismatched input transistors.

Question 19

What is an instrumentation amplifier?

  1. A power amplifier
  2. An oscillator
  3. A comparator only
  4. A high-gain differential amplifier with high input impedance and high CMRR, often made from three op-amps
Show answer & solution

Answer: (D) A high-gain differential amplifier with high input impedance and high CMRR, often made from three op-amps

It is used with sensors such as strain gauges.

Question 20

What is an active filter?

  1. A filter that uses op-amps with resistors and capacitors to give gain and sharp response without inductors
  2. A passive RC filter only
  3. A filter made only of inductors
  4. A mechanical filter
Show answer & solution

Answer: (A) A filter that uses op-amps with resistors and capacitors to give gain and sharp response without inductors

Sallen–Key and multiple-feedback filters are common types.

Question 21

What does a precision rectifier using an op-amp achieve?

  1. Amplification of DC only
  2. Rectification of very small signals without the diode voltage drop
  3. Oscillation
  4. Filtering of high frequencies only
Show answer & solution

Answer: (B) Rectification of very small signals without the diode voltage drop

The diode is placed inside the feedback loop.

Question 22

What is the output of a logarithmic amplifier proportional to?

  1. The square of the input
  2. The integral of the input
  3. The input
  4. The logarithm of the input
Show answer & solution

Answer: (D) The logarithm of the input

A diode or transistor in feedback gives the log characteristic.

Question 23

What is the CMRR of an ideal op-amp?

  1. 100 dB exactly
  2. Zero
  3. Infinite
  4. One
Show answer & solution

Answer: (C) Infinite

Practical op-amps have CMRR of 80–120 dB.

Question 24

What is a virtual ground in an inverting amplifier?

  1. The inverting input stays at ground potential though not physically connected to ground
  2. The supply is grounded
  3. The feedback resistor is grounded
  4. The output is grounded
Show answer & solution

Answer: (A) The inverting input stays at ground potential though not physically connected to ground

This simplifies analysis of summing and inverting amplifiers.

Question 25

What is the unity-gain bandwidth of an op-amp?

  1. The frequency at which its open-loop gain falls to one
  2. The slew rate
  3. The frequency of maximum gain
  4. The power supply frequency
Show answer & solution

Answer: (A) The frequency at which its open-loop gain falls to one

For a 741 it is about 1 MHz.

Question 26

What happens to the output of an op-amp if its gain would demand more than the supply voltage?

  1. It goes infinite
  2. It becomes zero
  3. It reverses permanently
  4. It saturates near the supply rail
Show answer & solution

Answer: (D) It saturates near the supply rail

Output swing is limited by the supply voltages.

Question 27

What is a difference amplifier?

  1. A buffer
  2. An integrator
  3. An op-amp circuit whose output is proportional to the difference between two input voltages
  4. A summing amplifier
Show answer & solution

Answer: (C) An op-amp circuit whose output is proportional to the difference between two input voltages

Matched resistors are needed for good CMRR.

Practice these 27 questions interactively →