Engineering, Management, Agriculture and Veterinary MCQs are now live. FPSC, PPSC, EPE, IELTS & GRE coming soon.

Mine Ventilation & Environment: Mine Gases

Mining Engineering · Mine Ventilation & Environment

39 questions, each with the answer and a worked solution.

Practice interactively and track your score →
Question 1

What is firedamp?

  1. Hydrogen sulphide
  2. Carbon dioxide and nitrogen
  3. Carbon monoxide
  4. Methane gas found in coal mines
Show answer & solution

Answer: (D) Methane gas found in coal mines

Firedamp is the miners' name for methane (CH₄).

Question 2

What is the explosive range of methane in air?

  1. 1% to 3%
  2. 5% to 15%
  3. 20% to 40%
  4. 50% to 75%
Show answer & solution

Answer: (B) 5% to 15%

Below 5% the mixture is too lean and above 15% too rich to explode.

Question 3

At about what concentration is methane most explosive in air?

  1. 2%
  2. 9.5%
  3. 15%
  4. 25%
Show answer & solution

Answer: (B) 9.5%

At about 9.5% methane combines with all the oxygen present.

Question 4

How does the density of methane compare with air?

  1. It is ten times heavier
  2. It has exactly the same density
  3. It is lighter, with a specific gravity of about 0.55
  4. It is heavier, with a specific gravity of 1.5
Show answer & solution

Answer: (C) It is lighter, with a specific gravity of about 0.55

Methane tends to accumulate near the roof and in rise workings.

Question 5

How is methane formed in coal seams?

  1. By decomposition of plant material during coalification
  2. By blasting with ANFO
  3. By battery charging
  4. By breathing of miners
Show answer & solution

Answer: (A) By decomposition of plant material during coalification

Methane is held in the coal and released as it is mined.

Question 6

What is methane layering?

  1. Layers of water in a sump
  2. Layers of coal in a seam
  3. Layers of dust on the floor
  4. Accumulation of a layer of methane along the roof of an airway
Show answer & solution

Answer: (D) Accumulation of a layer of methane along the roof of an airway

Layering occurs where air velocity is too low to mix the gas.

Question 7

How is methane layering prevented?

  1. By reducing ventilation
  2. By spraying oil
  3. By keeping enough air velocity along the roof to mix the gas
  4. By raising the temperature
Show answer & solution

Answer: (C) By keeping enough air velocity along the roof to mix the gas

Air velocities of at least about 0.5 m/s help prevent layering.

Question 8

What is blackdamp?

  1. An oxygen-deficient mixture of carbon dioxide and nitrogen
  2. Carbon monoxide
  3. Pure methane
  4. Hydrogen sulphide
Show answer & solution

Answer: (A) An oxygen-deficient mixture of carbon dioxide and nitrogen

Blackdamp extinguishes flames and can suffocate miners.

Question 9

What is afterdamp?

  1. The mixture of gases left after a mine fire or explosion
  2. Methane drained from seams
  3. Fresh intake air
  4. Gas released before blasting
Show answer & solution

Answer: (A) The mixture of gases left after a mine fire or explosion

Carbon monoxide in afterdamp is the main cause of deaths after explosions.

Question 10

Which gas is known as whitedamp?

  1. Methane
  2. Carbon monoxide
  3. Hydrogen
  4. Carbon dioxide
Show answer & solution

Answer: (B) Carbon monoxide

CO is colourless, odourless and highly toxic.

Question 11

Which gas is known as stinkdamp because of its rotten-egg smell?

  1. Carbon monoxide
  2. Nitrogen
  3. Hydrogen sulphide
  4. Methane
Show answer & solution

Answer: (C) Hydrogen sulphide

H₂S is toxic and deadens the sense of smell at high concentrations.

Question 12

Why is carbon monoxide so dangerous to miners?

  1. It is lighter than hydrogen
  2. It smells strongly
  3. It is visible
  4. It combines with haemoglobin about 200 to 300 times more readily than oxygen
Show answer & solution

Answer: (D) It combines with haemoglobin about 200 to 300 times more readily than oxygen

CO prevents the blood from carrying oxygen.

Question 13

What is the specific gravity of carbon monoxide relative to air?

  1. About 0.55
  2. About 0.97
  3. About 1.53
  4. About 2.5
Show answer & solution

Answer: (B) About 0.97

CO mixes readily with air because its density is close to that of air.

Question 14

Where does carbon dioxide tend to accumulate in mine workings?

  1. In return airways only near fans
  2. At the roof
  3. In low-lying places such as dips and sumps
  4. It never accumulates
Show answer & solution

Answer: (C) In low-lying places such as dips and sumps

CO₂ has a specific gravity of about 1.53.

Question 15

What is the normal percentage of oxygen in fresh air?

  1. About 15%
  2. About 20.9%
  3. About 25%
  4. About 30%
Show answer & solution

Answer: (B) About 20.9%

Fresh air is about 78% nitrogen, 21% oxygen and small amounts of other gases.

Question 16

About what is the minimum oxygen content normally required in mine air under regulations?

  1. About 5%
  2. About 10%
  3. About 19%
  4. About 25%
Show answer & solution

Answer: (C) About 19%

Below this level, people's work and judgement are affected.

Question 17

Which toxic reddish-brown gas is produced by explosives and diesel engines?

  1. Nitrogen dioxide
  2. Carbon dioxide
  3. Hydrogen
  4. Methane
Show answer & solution

Answer: (A) Nitrogen dioxide

NO₂ is highly toxic and irritates the lungs.

Question 18

What is the explosive range of hydrogen in air?

  1. About 0.5% to 1%
  2. About 4% to 74%
  3. About 5% to 15%
  4. About 80% to 95%
Show answer & solution

Answer: (B) About 4% to 74%

Hydrogen is given off when batteries are charged.

Question 19

Where must hydrogen hazards be controlled in underground mines?

  1. At the shaft collar only
  2. In the lamp room only for oil lamps
  3. At the magazine only
  4. At battery charging stations
Show answer & solution

Answer: (D) At battery charging stations

Charging stations are ventilated directly to the return.

Question 20

How does a flame safety lamp indicate methane?

  1. The flame turns green
  2. The glass breaks
  3. The lamp becomes cold
  4. A pale blue gas cap forms above the lowered flame
Show answer & solution

Answer: (D) A pale blue gas cap forms above the lowered flame

The height of the cap indicates the methane percentage.

Question 21

What does a flame safety lamp show in oxygen-deficient air?

  1. The flame becomes dim or goes out
  2. The flame grows taller
  3. A blue cap appears
  4. The lamp explodes
Show answer & solution

Answer: (A) The flame becomes dim or goes out

The flame needs oxygen to burn.

Question 22

Which sensor is most commonly used in hand-held methanometers?

  1. Litmus paper
  2. Mercury thermometer
  3. Magnetic compass
  4. Catalytic oxidation (pellistor) sensor
Show answer & solution

Answer: (D) Catalytic oxidation (pellistor) sensor

Methane burning on the heated catalyst changes its resistance.

Question 23

What is a limitation of catalytic methane sensors?

  1. They give false readings in high methane or low oxygen atmospheres
  2. They need sunlight
  3. They cannot detect methane at all
  4. They are affected by noise
Show answer & solution

Answer: (A) They give false readings in high methane or low oxygen atmospheres

Infrared sensors are used for high-range methane measurement.

Question 24

Which device gives a quick colour-change measurement of gases such as CO?

  1. Anemometer
  2. Hygrometer
  3. Detector (stain) tube with a hand pump
  4. Planimeter
Show answer & solution

Answer: (C) Detector (stain) tube with a hand pump

Dräger-type tubes change colour in proportion to gas concentration.

Question 25

What does a Coward's diagram show?

  1. Dust size
  2. Fan characteristics
  3. Rock strength
  4. Whether a mixture of methane, oxygen and inert gases is explosive
Show answer & solution

Answer: (D) Whether a mixture of methane, oxygen and inert gases is explosive

It is used to assess sealed fire areas and goaf atmospheres.

Question 26

What is a gas outburst in coal mining?

  1. A water inflow
  2. A slow seepage of gas
  3. A sudden violent release of gas and coal into the workings
  4. A blast of fresh air
Show answer & solution

Answer: (C) A sudden violent release of gas and coal into the workings

Outbursts occur in highly gassy, stressed seams.

Question 27

What is the main purpose of methane drainage?

  1. To capture methane from seams before or after mining so that ventilation can control the rest
  2. To dry the coal
  3. To cool the mine
  4. To increase gas in the workings
Show answer & solution

Answer: (A) To capture methane from seams before or after mining so that ventilation can control the rest

Drained gas may be used as fuel.

Question 28

Which radioactive gas is a health hazard in uranium and some other mines?

  1. Argon
  2. Radon
  3. Neon
  4. Helium
Show answer & solution

Answer: (B) Radon

Radon and its decay products cause lung cancer.

Question 29

Which gas is produced when sulphide ores are blasted or oxidise?

  1. Argon
  2. Methane
  3. Sulphur dioxide
  4. Hydrogen
Show answer & solution

Answer: (C) Sulphur dioxide

SO₂ is irritating and toxic.

Question 30

What is the ignition temperature of methane approximately?

  1. About 30 °C
  2. About 100 °C
  3. About 650 to 750 °C
  4. About 2,000 °C
Show answer & solution

Answer: (C) About 650 to 750 °C

Hot surfaces, sparks and flames can reach this temperature.

Question 31

Which monitoring system draws air samples through tubes to a surface analyser?

  1. Tube bundle system
  2. Smoke tube
  3. Kata thermometer
  4. Pitot tube
Show answer & solution

Answer: (A) Tube bundle system

Tube bundles monitor gases in sealed and goaf areas continuously.

Question 32

What is seam gas content usually expressed in?

  1. Grams per litre of water
  2. Cubic metres of gas per tonne of coal
  3. Pascals
  4. Millimetres per second
Show answer & solution

Answer: (B) Cubic metres of gas per tonne of coal

Gas content helps predict methane emissions and outburst risk.

Question 33

What is the explosive range of carbon monoxide in air?

  1. It is not flammable
  2. About 1% to 3%
  3. About 5% to 15%
  4. About 12.5% to 74%
Show answer & solution

Answer: (D) About 12.5% to 74%

CO is both toxic and flammable.

Question 34

What is the explosive range of hydrogen sulphide in air?

  1. About 0.1% to 0.5%
  2. About 60% to 90%
  3. It is not flammable
  4. About 4.3% to 46%
Show answer & solution

Answer: (D) About 4.3% to 46%

H₂S is usually toxic long before it reaches explosive levels.

Question 35

What is the main cause of oxygen deficiency in old, unventilated workings?

  1. Oxidation of coal and timber and accumulation of other gases
  2. Excess ventilation
  3. Too much methane drainage
  4. Use of water sprays
Show answer & solution

Answer: (A) Oxidation of coal and timber and accumulation of other gases

Miners must never enter unventilated old workings without testing.

Question 36

What is the danger of entering an atmosphere containing blackdamp?

  1. Burns from acid
  2. Suffocation due to lack of oxygen
  3. Explosion due to hydrogen
  4. Radiation
Show answer & solution

Answer: (B) Suffocation due to lack of oxygen

Blackdamp gives no warning by smell.

Question 37

Which gas detection practice is required before shotfiring in gassy coal mines?

  1. Testing the wind direction
  2. Testing for methane at the place of firing
  3. Testing for argon
  4. Testing air temperature only
Show answer & solution

Answer: (B) Testing for methane at the place of firing

Shots must not be fired if methane is present above the permitted limit.

Question 38

Why must gas tests be made at the roof in coal mine workings?

  1. Methane is lighter than air and collects near the roof
  2. Gas is evenly mixed everywhere
  3. Methane collects at the floor
  4. Carbon dioxide collects at the roof
Show answer & solution

Answer: (A) Methane is lighter than air and collects near the roof

Roof cavities and rise ends are common places for methane accumulation.

Question 39

Why is a flame safety lamp protected by wire gauze?

  1. To filter dust
  2. To make the lamp heavier
  3. To increase light
  4. The gauze cools the flame so that it cannot ignite surrounding methane
Show answer & solution

Answer: (D) The gauze cools the flame so that it cannot ignite surrounding methane

This principle was introduced by Sir Humphry Davy in 1815.

Practice these 39 questions interactively →