What size of airborne dust particle is considered respirable?
Show answer & solution
Answer: (C) Particles smaller than about 5 micrometres
Respirable dust reaches deep into the lungs.
Mining Engineering · Mine Ventilation & Environment
37 questions, each with the answer and a worked solution.
Practice interactively and track your score →What size of airborne dust particle is considered respirable?
Answer: (C) Particles smaller than about 5 micrometres
Respirable dust reaches deep into the lungs.
Which lung disease is caused by breathing crystalline silica dust?
Answer: (A) Silicosis
Silicosis is incurable and increases the risk of tuberculosis.
What is coal workers' pneumoconiosis commonly called?
Answer: (B) Black lung
It results from long exposure to respirable coal dust.
Which lung disease results from inhaling asbestos fibres?
Answer: (C) Asbestosis
Asbestos is found in some ultramafic rocks and old insulation.
What is the most effective primary method of dust control at its source?
Answer: (A) Water sprays and wet cutting or drilling
Suppression at the source stops dust becoming airborne.
Which instrument samples respirable dust by mass for comparison with exposure limits?
Answer: (B) Gravimetric personal dust sampler with a cyclone
The cyclone removes non-respirable particles.
What did the konimeter measure in older dust surveys?
Answer: (D) The number of dust particles in a small air sample
Particle counting has been replaced by gravimetric sampling.
What three conditions are needed for a coal dust explosion?
Answer: (C) Fine dust dispersed in air above a minimum concentration and an ignition source
An initial methane explosion often raises the dust.
What is the approximate lower explosive limit of coal dust in air?
Answer: (C) About 50 g/m³
Such concentrations occur when settled dust is raised by a blast.
What is stone dusting in coal mines?
Answer: (A) Spreading inert rock dust, usually limestone, on roadway surfaces to prevent coal dust explosions
Inert dust absorbs heat and stops flame propagation.
Why is limestone dust preferred for stone dusting?
Answer: (D) It is inert and has a low free silica content
High-silica dust would cause silicosis.
What are stone dust barriers?
Answer: (B) Shelves of stone dust that tip over and disperse in the path of an explosion
The dispersed cloud quenches the advancing flame.
What are water barriers in coal mines?
Answer: (B) Water-filled troughs or bags that burst in an explosion to quench the flame
Water barriers serve the same purpose as stone dust barriers.
What is a secondary explosion in a coal mine?
Answer: (A) A coal dust explosion triggered when a primary explosion raises dust
Secondary dust explosions can spread through the whole mine.
How does the volatile matter content of coal affect the explosibility of its dust?
Answer: (D) Higher volatile matter makes the dust more explosive
Anthracite dust is less explosive than high-volatile bituminous dust.
Which unit and weighting are used to assess workplace noise exposure?
Answer: (A) Decibels on the A-weighted scale, dB(A)
A-weighting matches the response of the human ear.
At about what daily noise exposure level is action, such as hearing protection, normally required?
Answer: (C) About 85 dB(A) over 8 hours
Many standards set 85 dB(A) as the action level.
What does an increase of about 3 dB in noise level represent?
Answer: (D) A doubling of sound energy
Permitted exposure time is halved for every 3 dB increase.
What is the main health effect of long exposure to high noise?
Answer: (B) Noise-induced hearing loss
Hearing loss from noise is permanent.
Which test checks miners' hearing to detect early noise-induced hearing loss?
Answer: (A) Audiometry
Regular audiograms track hearing changes.
How are diesel particulate emissions underground reduced?
Answer: (C) Exhaust filters, low-sulphur fuel, engine maintenance and adequate ventilation
Diesel particulate matter is a known carcinogen.
Which eye disease was once common in coal miners working in poor light?
Answer: (B) Miners' nystagmus
Better cap lamps and lighting have largely eliminated it.
What is the purpose of dust extraction (scrubber) systems on continuous miners and roadheaders?
Answer: (D) To draw dusty air from the cutting head and remove the dust
Scrubbers capture a large part of the dust at the source.
Why are conveyor transfer points often enclosed and fitted with sprays?
Answer: (D) They generate large amounts of dust
Falling coal at transfer points raises dust.
What is the purpose of a dust respirator?
Answer: (B) To filter dust from the air breathed by the worker
Respirators are a last line of defence after engineering controls.
What is the main environmental concern with mine water discharged to rivers?
Answer: (A) Acidity, suspended solids and dissolved metals
Mine water may need settling and treatment before discharge.
In which unit is exposure to radon decay products in uranium mines often expressed?
Answer: (C) Working level months (WLM)
Radon exposure is controlled by ventilation.
What is the main purpose of ventilation in controlling airborne dust?
Answer: (B) To dilute and carry away dust that cannot be suppressed at the source
Air velocity must be enough to carry dust without raising settled dust.
Which mining activity typically produces the most respirable dust in coal mines?
Answer: (C) Coal cutting at the face
Cutting machines generate dust that must be suppressed and extracted.
Why must the incombustible content of roadway dust be sampled regularly in coal mines?
Answer: (D) To make sure enough stone dust is present to prevent explosion propagation
Regulations specify minimum incombustible contents.
What is the main purpose of hearing protection such as earmuffs and earplugs?
Answer: (A) To reduce noise reaching the ear
Hearing protectors are used where noise cannot be reduced at source.
Which engineering control reduces noise from rock drills and fans?
Answer: (C) Silencers and enclosures
Engineering controls are preferred to relying only on hearing protectors.
What is the main purpose of personal dust exposure monitoring in mines?
Answer: (C) To check that workers are not exposed above legal dust limits
Results guide improvements in dust control.
Which mineral dust is mainly responsible for silicosis in quarry and hard-rock workers?
Answer: (A) Quartz (crystalline silica)
Drilling and crushing quartz-rich rock release fine silica dust.
Why should dry sweeping of dusty roadways be avoided?
Answer: (D) It raises fine dust into the air
Wet methods or vacuum cleaning are preferred.
What is the purpose of water sprays on haul roads and at dumps in surface mines?
Answer: (B) To suppress airborne dust
Dust from haul roads is the largest dust source in many open pits.
What is the effect of low-sulphur diesel fuel on underground air quality?
Answer: (C) It reduces sulphur dioxide and particulate emissions
Low-sulphur fuel also allows effective exhaust treatment.