What is refrigeration?
Show answer & solution
Answer: (D) The process of removing heat from a space or substance and keeping it below the temperature of its surroundings
Heat is rejected at a higher temperature to the surroundings.
Mechanical Engineering · Refrigeration & Air Conditioning
33 questions, each with the answer and a worked solution.
Practice interactively and track your score →What is refrigeration?
Answer: (D) The process of removing heat from a space or substance and keeping it below the temperature of its surroundings
Heat is rejected at a higher temperature to the surroundings.
Which law of thermodynamics shows that work is needed to transfer heat from a cold body to a hot body?
Answer: (B) Second law (Clausius statement)
A refrigerator needs a work or heat input to operate.
What is the coefficient of performance (COP) of a refrigerator?
Answer: (C) The ratio of refrigerating effect (heat removed) to work input
COP of a refrigerator is usually greater than 1.
How does heat absorbed in the evaporator of a refrigerator compare with heat rejected in the condenser?
Answer: (A) It is less, because the condenser also rejects the compressor work
Heat rejected = heat absorbed + work input.
What is the COP of a Carnot refrigerator working between −23 °C and 27 °C?
Answer: (C) 5
COP = T₂/(T₁ − T₂) = 250/50.
What is the COP of a Carnot heat pump working between −23 °C and 27 °C?
Answer: (D) 6
COP_HP = T₁/(T₁ − T₂) = 300/50.
How is the COP of a heat pump related to the COP of a refrigerator between the same temperatures?
Answer: (B) COP of heat pump = COP of refrigerator + 1
The heat pump delivers both the heat absorbed and the work input.
A Carnot engine has an efficiency of 80%. What is the COP of the same engine reversed as a refrigerator?
Answer: (A) 0.25
COP = (1 − η)/η = 0.2/0.8.
What is relative COP?
Answer: (B) The ratio of actual COP to theoretical COP
It shows how close a system is to its ideal cycle.
What is one tonne of refrigeration (TR) based on?
Answer: (A) The heat removed to freeze one ton of water at 0 °C into ice at 0 °C in 24 hours
It is a traditional unit of refrigerating capacity.
What is one tonne of refrigeration equal to in SI units?
Answer: (C) About 3.5 kW (about 211 kJ/min)
It is also about 50 kcal/min.
What is the approximate capacity of a typical domestic refrigerator?
Answer: (A) About 0.1 tonne of refrigeration
Room air conditioners are typically 1–2 tonnes.
What is the approximate compressor power needed per tonne of refrigeration in common systems?
Answer: (B) About 1 to 2 hp
It depends on operating temperatures.
On which cycle does a vapour compression refrigerator ideally work?
Answer: (D) Reversed Carnot cycle, approximated in practice by the vapour compression (reversed Rankine) cycle
The practical cycle replaces the expansion engine by a throttling valve.
Why is the reversed Carnot cycle not used in practical refrigerators?
Answer: (C) Isentropic compression of wet vapour and an expansion engine are impractical, and isothermal processes are hard to achieve
The vapour compression cycle is a practical alternative.
On which cycle does an air refrigeration system work?
Answer: (D) Bell–Coleman (reversed Brayton or reversed Joule) cycle
It uses air as the refrigerant.
Where is air refrigeration mainly used?
Answer: (C) Aircraft cabin cooling
Air is light, safe and freely available on aircraft.
Why is the COP of an air refrigeration system low?
Answer: (A) Air has low heat-carrying capacity, so large volumes must be handled with no change of phase
Vapour systems use latent heat of evaporation.
What is a heat pump?
Answer: (B) A device that uses work to transfer heat from a cold region to a warm region for heating purposes
Reversible air conditioners act as heat pumps in winter.
What is meant by the refrigerating effect?
Answer: (D) The amount of heat absorbed by the refrigerant in the evaporator per unit mass
It equals the enthalpy rise in the evaporator.
Why must the temperature of the space being cooled be higher than the evaporator temperature?
Answer: (D) Heat flows only from a higher to a lower temperature
The evaporator must be colder than the space it cools.
What is the usual temperature difference between the evaporating refrigerant and the medium being cooled?
Answer: (A) As small as practical, about 3–11 °C
A smaller difference gives a higher COP but needs a larger evaporator.
What is a standard ice point?
Answer: (B) The temperature of a mixture of ice and water in equilibrium at standard atmospheric pressure (0 °C)
It is a fixed reference point for temperature scales.
What is the main application of refrigeration in food preservation?
Answer: (A) Slowing the growth of bacteria and chemical changes by keeping food at low temperatures
Cold storage is widely used for fruits and vegetables in Pakistan.
What is the usual temperature of a domestic freezer compartment?
Answer: (D) About −18 °C
Fresh food compartments are kept at about 2–5 °C.
What is a cold storage plant?
Answer: (B) A facility that stores perishable goods at controlled low temperatures and humidity
Potato and fruit cold stores are common in Punjab.
What is an ice plant?
Answer: (A) A plant that produces ice blocks, usually using brine cooled by ammonia refrigeration
Cans of water are immersed in cold brine.
What is brine in refrigeration?
Answer: (B) A salt solution with a low freezing point used as a secondary refrigerant
Calcium chloride and sodium chloride brines are common.
What is a secondary refrigerant?
Answer: (C) A fluid cooled by the primary refrigerant and then used to cool the product or space
Brine and chilled water are secondary refrigerants.
Why does a refrigerator in a closed room warm the room when its door is left open?
Answer: (D) The heat removed is put back into the room together with the compressor work
Energy is conserved in the room.
What is the unit "kcal/hr" commonly converted to for refrigeration capacity?
Answer: (B) Tonnes of refrigeration, where 1 TR is about 3000 kcal/hr
1 TR ≈ 3024 kcal/hr.
What is the energy efficiency ratio (EER) of an air conditioner?
Answer: (A) The cooling capacity in Btu/h divided by the power input in watts
A higher EER means a more efficient unit.
Why are inverter air conditioners more energy efficient than fixed-speed units?
Answer: (D) They vary compressor speed to match load, avoiding frequent on–off cycling
This saves electricity during part-load operation.