How is fuel ignited in a diesel engine?
Show answer & solution
Answer: (A) By the heat of air compressed to a high temperature
Air temperature at the end of compression may exceed 500 °C.
Mechanical Engineering · Internal Combustion Engines
33 questions, each with the answer and a worked solution.
Practice interactively and track your score →How is fuel ignited in a diesel engine?
Answer: (A) By the heat of air compressed to a high temperature
Air temperature at the end of compression may exceed 500 °C.
What is compressed in a diesel engine cylinder during the compression stroke?
Answer: (D) Air alone
Fuel is injected near the end of compression.
Why can diesel engines run on very lean overall mixtures?
Answer: (C) Fuel is injected and burned locally where it meets air, so overall air–fuel ratio can vary widely
Diesel engines are quality governed.
What type of combustion takes place in a CI engine?
Answer: (B) Heterogeneous combustion
Fuel droplets and air are not uniformly mixed.
What does the cetane number of diesel fuel indicate?
Answer: (A) Its ignition quality, or ease of self-ignition
Higher cetane fuels have a shorter ignition delay.
Which reference fuels are used to determine cetane number?
Answer: (D) n-cetane (hexadecane, rated 100) and α-methylnaphthalene (rated 0)
Cetane is a straight-chain paraffin.
How does the self-ignition temperature of diesel compare with petrol?
Answer: (B) It is lower
This is why diesel ignites readily under compression.
What is ignition delay in a diesel engine?
Answer: (C) The time between the start of fuel injection and the start of combustion
It is usually about 0.001–0.002 seconds.
What are the four stages of combustion in a CI engine?
Answer: (A) Ignition delay, rapid (uncontrolled) combustion, controlled combustion and after-burning
Long delay causes diesel knock.
What causes knocking in a diesel engine?
Answer: (C) Rapid burning of a large amount of fuel accumulated during a long ignition delay
It occurs at the start of combustion, not at the end.
Which factors reduce knocking in a diesel engine?
Answer: (B) High compression ratio, high intake temperature, high cetane fuel and short ignition delay
These are the opposite of the factors that reduce knock in petrol engines.
What is the effect of decreasing the compression ratio of a diesel engine on knocking?
Answer: (A) It increases knocking
Lower compression gives lower air temperature and longer delay.
What happens if petrol is used in a diesel engine?
Answer: (D) Heavy knocking occurs because petrol has poor self-ignition quality
Petrol has a high self-ignition temperature.
What is atomisation of fuel?
Answer: (B) Breaking liquid fuel into very fine droplets by spraying
Good atomisation is essential in diesel engines.
What is solid injection in diesel engines?
Answer: (A) Injection of liquid fuel alone at high pressure through a nozzle
Air injection, used in early engines, is now obsolete.
What is a common rail diesel injection system?
Answer: (D) A system in which a high-pressure pump feeds fuel to a shared rail, and electronically controlled injectors spray it into each cylinder
Injection pressures can exceed 1500 bar.
What is the function of a fuel injection pump in a diesel engine?
Answer: (C) To meter and deliver fuel at high pressure to the injectors at the correct time
In-line and distributor pumps are common types.
What is an open (direct injection) combustion chamber in a diesel engine?
Answer: (D) A chamber in the piston crown where fuel is injected directly, with turbulence produced by the inlet port and piston shape
It gives good fuel economy.
What is a pre-combustion chamber in a diesel engine?
Answer: (A) A small auxiliary chamber where combustion starts in a fuel-rich zone before spreading to the main chamber
It gives smoother combustion and tolerates poorer fuels.
What is a turbulence (swirl) chamber in a diesel engine?
Answer: (C) An auxiliary chamber connected to the cylinder by a throat, in which strong air swirl is created during compression
The Ricardo Comet is a well-known swirl chamber design.
Why are glow plugs fitted in some diesel engines?
Answer: (B) To help cold starting by heating the combustion chamber
They are common in indirect-injection engines.
What is the approximate maximum temperature of gases in an IC engine cylinder during combustion?
Answer: (C) About 2000–2500 °C
The cylinder walls are protected by cooling.
Which of the following is a major cause of diesel smoke?
Answer: (A) Over-fuelling and poor mixing of fuel with air
Black smoke consists of unburned carbon particles.
What is injection lag in a diesel engine?
Answer: (C) The delay between the start of the pump plunger's delivery stroke and the actual start of injection at the nozzle
It is caused by fuel compressibility and pipe length.
What is the approximate air pressure at the end of compression in a diesel engine?
Answer: (C) About 35–50 bar
Petrol engines reach only about 6–12 bar.
Why do diesel engines have lower specific fuel consumption than petrol engines at both part and full load?
Answer: (B) Higher compression ratio, lean overall mixture and no throttling losses
Diesel fuel also has higher energy per litre.
What is a multi-hole nozzle used for?
Answer: (A) Direct-injection diesel engines, to spread fine fuel sprays across the combustion chamber
Pintle nozzles are used with indirect-injection chambers.
What is the role of swirl in diesel combustion?
Answer: (D) To mix injected fuel rapidly with air for complete combustion
Swirl is produced by intake port shape and combustion chamber design.
What is the effect of high cetane number on diesel engine starting?
Answer: (C) It makes cold starting easier
Short ignition delay helps the engine start quickly.
Why must the injector nozzle tip be kept at a suitable temperature?
Answer: (B) Overheating causes carbon deposits, while too low a temperature causes poor atomisation
Carbon blocks the spray holes.
What is the effect of excess sulphur in diesel fuel?
Answer: (D) Corrosion and wear of engine parts and higher sulphur oxide emissions
Low-sulphur diesel is needed for modern emission controls.
Why is diesel fuel's volatility less important than its ignition quality?
Answer: (A) Diesel fuel is injected and burned in compressed hot air rather than vaporised in a carburettor
Ignition quality controls delay and knock.
What is a dual-fuel engine?
Answer: (A) A compression ignition engine that burns gaseous fuel ignited by a small pilot injection of diesel
Natural gas dual-fuel engines are used in power generation.