Engineering, Management, Agriculture and Veterinary MCQs are now live. FPSC, PPSC, EPE, IELTS & GRE coming soon.

Electrical Machines: Synchronous Machines

Electrical Engineering · Electrical Machines

37 questions, each with the answer and a worked solution.

Practice interactively and track your score →
Question 1

At what speed does a synchronous machine run under steady conditions?

  1. Any speed depending on load
  2. Slightly below synchronous speed
  3. Twice synchronous speed
  4. Synchronous speed, determined by frequency and number of poles
Show answer & solution

Answer: (D) Synchronous speed, determined by frequency and number of poles

N = 120f/P exactly.

Question 2

Why do large alternators have a stationary armature and a rotating field?

  1. The field is heavier
  2. High-voltage armature windings are easier to insulate and connect when stationary
  3. Stationary fields are impossible
  4. It reduces frequency
Show answer & solution

Answer: (B) High-voltage armature windings are easier to insulate and connect when stationary

Only low-power DC field current passes through slip rings.

Question 3

Which rotor type is used in low-speed hydroelectric generators such as those at Tarbela and Mangla?

  1. Cylindrical (non-salient) rotor
  2. Squirrel-cage rotor
  3. Salient-pole rotor
  4. Wound rotor with slip rings
Show answer & solution

Answer: (C) Salient-pole rotor

Low speed needs many poles, which suits salient poles.

Question 4

Which rotor type is used in high-speed steam and gas turbine alternators?

  1. Cylindrical (non-salient) rotor
  2. Squirrel-cage rotor
  3. Salient-pole rotor
  4. Shaded-pole rotor
Show answer & solution

Answer: (A) Cylindrical (non-salient) rotor

Two- or four-pole cylindrical rotors withstand high centrifugal forces.

Question 5

How many poles does a 50 Hz alternator running at 3,000 rpm have?

  1. 2
  2. 4
  3. 6
  4. 8
Show answer & solution

Answer: (A) 2

P = 120f/N = 120 × 50/3000 = 2.

Question 6

What is the speed of a 48-pole hydro generator on a 50 Hz system?

  1. 62.5 rpm
  2. 125 rpm
  3. 250 rpm
  4. 3,000 rpm
Show answer & solution

Answer: (B) 125 rpm

N = 120 × 50/48 = 125 rpm.

Question 7

What is the emf equation of an alternator per phase?

  1. E = ΦN/(Kp Kd)
  2. E = PΦZN/(60A)
  3. E = 4.44 f Φ N Kp Kd
  4. E = 4.44 f N/Φ
Show answer & solution

Answer: (C) E = 4.44 f Φ N Kp Kd

Kp and Kd are the pitch and distribution factors.

Question 8

Why are short-pitched coils used in alternator windings?

  1. To reduce frequency
  2. To increase harmonics
  3. To increase the emf above full-pitch
  4. To reduce harmonics and save copper in end connections
Show answer & solution

Answer: (D) To reduce harmonics and save copper in end connections

Pitch factor is slightly less than one.

Question 9

Which method of finding alternator voltage regulation is known to be pessimistic?

  1. ASA method
  2. MMF method
  3. EMF (synchronous impedance) method
  4. Zero power factor (Potier) method
Show answer & solution

Answer: (C) EMF (synchronous impedance) method

The MMF method is optimistic.

Question 10

Which tests are used to find the synchronous impedance of an alternator?

  1. Open-circuit and short-circuit tests
  2. Polarity test
  3. Blocked rotor and no-load tests
  4. Swinburne's test
Show answer & solution

Answer: (A) Open-circuit and short-circuit tests

Zs = open-circuit voltage/short-circuit current at the same field current.

Question 11

What is the effect of armature reaction in an alternator supplying a lagging power factor load?

  1. It has no effect
  2. It only distorts the field
  3. It is magnetising
  4. It is demagnetising and reduces terminal voltage
Show answer & solution

Answer: (D) It is demagnetising and reduces terminal voltage

Leading loads have a magnetising effect.

Question 12

Why is a synchronous motor not self-starting?

  1. Its stator has no winding
  2. The rotating field moves too fast for the rotor to lock in from rest
  3. It runs on DC only
  4. It has no field winding
Show answer & solution

Answer: (B) The rotating field moves too fast for the rotor to lock in from rest

Damper windings or a pony motor are used for starting.

Question 13

What happens to a synchronous motor when its field excitation is increased beyond normal?

  1. Its frequency increases
  2. Its speed decreases sharply
  3. It draws leading current
  4. It draws lagging current
Show answer & solution

Answer: (C) It draws leading current

An over-excited synchronous motor supplies reactive power.

Question 14

What is a synchronous condenser?

  1. A DC motor
  2. A capacitor bank
  3. An induction generator
  4. An over-excited synchronous motor running without mechanical load to supply reactive power
Show answer & solution

Answer: (D) An over-excited synchronous motor running without mechanical load to supply reactive power

It improves power factor and supports voltage.

Question 15

What do the V-curves of a synchronous motor show?

  1. Armature current against field current at constant load
  2. Speed against torque
  3. Voltage against frequency
  4. Efficiency against load
Show answer & solution

Answer: (A) Armature current against field current at constant load

The minimum current occurs at unity power factor.

Question 16

What power factor does an under-excited synchronous motor operate at?

  1. Unity
  2. Lagging
  3. Zero always
  4. Leading
Show answer & solution

Answer: (B) Lagging

It absorbs reactive power from the supply.

Question 17

Which conditions must be met before synchronising an alternator with the grid?

  1. Equal current and power factor only
  2. Equal voltage, equal frequency, same phase sequence and phase angle
  3. Same manufacturer
  4. Equal speed and weight
Show answer & solution

Answer: (B) Equal voltage, equal frequency, same phase sequence and phase angle

A synchroscope shows when to close the breaker.

Question 18

What is an infinite bus?

  1. A system so large that its voltage and frequency stay constant regardless of the load of one machine
  2. A bus with no voltage
  3. A small isolated system
  4. A DC bus
Show answer & solution

Answer: (A) A system so large that its voltage and frequency stay constant regardless of the load of one machine

A large interconnected grid behaves as an infinite bus.

Question 19

How is the real power output of a synchronous generator related to the load angle δ?

  1. P = E/V
  2. P = (EV/Xs) cos δ
  3. P = EVXs
  4. P = (EV/Xs) sin δ
Show answer & solution

Answer: (D) P = (EV/Xs) sin δ

Maximum power occurs at δ = 90°.

Question 20

What is hunting in synchronous machines?

  1. Running below synchronous speed
  2. Overheating of the stator
  3. Oscillation of the rotor about its steady-state position after a disturbance
  4. Reversal of rotation
Show answer & solution

Answer: (C) Oscillation of the rotor about its steady-state position after a disturbance

Damper windings help reduce hunting.

Question 21

Which reactance primarily limits the initial short-circuit current of a synchronous generator?

  1. Subtransient reactance
  2. Synchronous reactance
  3. Magnetising reactance
  4. Armature resistance
Show answer & solution

Answer: (A) Subtransient reactance

X″d is smaller than X′d, which is smaller than Xd.

Question 22

What is a brushless excitation system?

  1. A capacitor bank
  2. A permanent magnet stator
  3. An AC exciter on the shaft with rotating rectifiers feeding the field without slip rings
  4. A DC exciter with brushes
Show answer & solution

Answer: (C) An AC exciter on the shaft with rotating rectifiers feeding the field without slip rings

It reduces maintenance in large generators.

Question 23

What does the automatic voltage regulator (AVR) of a generator control?

  1. The turbine speed
  2. The frequency
  3. The fuel supply
  4. The field excitation to keep terminal voltage constant
Show answer & solution

Answer: (D) The field excitation to keep terminal voltage constant

Excitation controls reactive power output.

Question 24

What does the governor of a generator mainly control?

  1. Field current
  2. Turbine input power and hence frequency and real power output
  3. Reactive power
  4. Terminal voltage
Show answer & solution

Answer: (B) Turbine input power and hence frequency and real power output

Load–frequency control uses governor action.

Question 25

Why is hydrogen used to cool large turbo-alternators?

  1. It is cheaper than air
  2. It has high thermal conductivity and low density, reducing windage loss
  3. It insulates better than oil
  4. It is non-flammable
Show answer & solution

Answer: (B) It has high thermal conductivity and low density, reducing windage loss

Hydrogen pressure is maintained to keep air out.

Question 26

Which theory analyses salient-pole machines using direct-axis and quadrature-axis reactances?

  1. Double revolving field theory
  2. Superposition theory
  3. Two-reaction (Blondel) theory
  4. Thevenin theory
Show answer & solution

Answer: (C) Two-reaction (Blondel) theory

In salient-pole machines Xd is greater than Xq.

Question 27

What happens to a synchronous motor's speed when its mechanical load increases within its limit?

  1. Speed falls in proportion
  2. Speed rises
  3. It stops immediately
  4. Speed stays constant and the load angle increases
Show answer & solution

Answer: (D) Speed stays constant and the load angle increases

If load exceeds the pull-out torque, it falls out of step.

Question 28

What are damper windings in synchronous machines?

  1. Short-circuited bars in the pole faces that damp oscillations and help starting
  2. The armature winding
  3. The main field winding
  4. The exciter winding
Show answer & solution

Answer: (A) Short-circuited bars in the pole faces that damp oscillations and help starting

They act like a squirrel cage.

Question 29

What is the short-circuit ratio (SCR) of an alternator?

  1. The ratio of short-circuit current to load current
  2. The ratio of field current for rated open-circuit voltage to field current for rated short-circuit current
  3. The ratio of speed to frequency
  4. The ratio of reactance to resistance
Show answer & solution

Answer: (B) The ratio of field current for rated open-circuit voltage to field current for rated short-circuit current

A high SCR gives better stability but a larger machine.

Question 30

What type of power does a synchronous generator supply when it is over-excited?

  1. Leading reactive power to the system
  2. Only DC power
  3. No reactive power
  4. Lagging reactive power to the system
Show answer & solution

Answer: (D) Lagging reactive power to the system

Over-excited generators supply VARs needed by inductive loads.

Question 31

What is pull-out torque of a synchronous motor?

  1. The torque at zero load angle
  2. The starting torque
  3. The maximum torque it can develop without losing synchronism
  4. The no-load torque
Show answer & solution

Answer: (C) The maximum torque it can develop without losing synchronism

It occurs at a load angle of 90° in a cylindrical rotor machine.

Question 32

What is the purpose of a synchroscope?

  1. To show the phase difference and frequency difference between an incoming machine and the bus
  2. To measure insulation
  3. To measure speed only
  4. To measure power factor
Show answer & solution

Answer: (A) To show the phase difference and frequency difference between an incoming machine and the bus

Its pointer rotation shows whether the incoming machine is fast or slow.

Question 33

Why are synchronous motors used in some industries in addition to driving loads?

  1. They run at constant speed and can improve plant power factor
  2. They have no excitation
  3. They are cheaper than induction motors
  4. They start without help
Show answer & solution

Answer: (A) They run at constant speed and can improve plant power factor

They are common in large compressors and mills.

Question 34

What is the frequency of the voltage generated by an alternator with P poles running at N rpm?

  1. f = 120P/N
  2. f = 120N/P
  3. f = N/(120P)
  4. f = PN/120
Show answer & solution

Answer: (D) f = PN/120

This relation fixes generator speed for 50 Hz.

Question 35

Why are hydro generators usually larger in diameter and shorter in length than turbo-alternators?

  1. They run at low speed with many poles
  2. They have fewer poles
  3. They run at very high speed
  4. They use no field winding
Show answer & solution

Answer: (A) They run at low speed with many poles

Turbo-alternators are long and narrow to limit centrifugal stress.

Question 36

What is the purpose of a pilot exciter in older excitation systems?

  1. To supply field current to the main exciter
  2. To start the turbine
  3. To measure speed
  4. To cool the generator
Show answer & solution

Answer: (A) To supply field current to the main exciter

Modern systems use static or brushless excitation.

Question 37

What does the load angle (power angle) of a synchronous machine represent?

  1. The power factor angle
  2. The angle of the shaft
  3. The angle between poles
  4. The angle between the internal emf and the terminal voltage
Show answer & solution

Answer: (D) The angle between the internal emf and the terminal voltage

Load angle increases with real power transfer.

Practice these 37 questions interactively →