What is the length of a half-wave dipole antenna for a 100 MHz signal?
Show answer & solution
Answer: (B) About 1.5 m
λ = 3 m, so λ/2 = 1.5 m.
Electrical Engineering · Communication & Signals
31 questions, each with the answer and a worked solution.
Practice interactively and track your score →What is the length of a half-wave dipole antenna for a 100 MHz signal?
Answer: (B) About 1.5 m
λ = 3 m, so λ/2 = 1.5 m.
What does antenna gain describe?
Answer: (D) How much an antenna concentrates power in a particular direction compared with a reference antenna
Gain is given in dBi or dBd.
What does an antenna radiation pattern show?
Answer: (A) The variation of radiated power with direction
Main lobes and side lobes appear on the pattern.
Which antenna is commonly used for receiving TV signals in homes?
Answer: (D) Yagi–Uda antenna
Yagi antennas have a driven element, reflector and directors.
Which antenna is used for satellite communication because of its very high gain?
Answer: (A) Parabolic reflector (dish) antenna
Dishes focus energy into a narrow beam.
Which mode of propagation allows HF signals to travel long distances by reflection from the ionosphere?
Answer: (C) Sky wave
HF (3–30 MHz) uses sky-wave propagation.
Which propagation mode is used by VHF, UHF and microwave links?
Answer: (B) Space wave (line-of-sight)
Antenna height limits the range.
What is the approximate altitude of a geostationary satellite above the equator?
Answer: (C) 35,786 km
At this altitude a satellite completes one orbit per day.
Which Pakistani communication satellite was launched in 2011 to provide broadcasting and telecommunications services?
Answer: (A) PakSat-1R
PakSat-MM1 was launched in 2024.
On which principle does an optical fibre guide light?
Answer: (B) Total internal reflection
The core has a higher refractive index than the cladding.
What is the main difference between single-mode and multimode optical fibres?
Answer: (D) Single-mode fibre has a very small core carrying one mode, giving low dispersion over long distances
Multimode fibre is used for short links.
At which wavelength does silica optical fibre have its lowest attenuation?
Answer: (D) About 1,550 nm
Long-haul systems use the 1,550 nm window.
What is frequency reuse in cellular systems?
Answer: (A) Using the same frequencies in cells far enough apart to avoid interference
Frequency reuse increases capacity.
What is handover in mobile communication?
Answer: (C) Transferring an ongoing call or data session from one cell to another as the user moves
Handover keeps the connection uninterrupted.
Which access technique was used in GSM 2G networks?
Answer: (B) TDMA combined with FDMA
Each carrier is divided into time slots.
Which body regulates the telecommunications sector in Pakistan?
Answer: (D) Pakistan Telecommunication Authority (PTA)
PTA licenses operators and manages spectrum policy with the Frequency Allocation Board.
What is the characteristic impedance of the coaxial cable commonly used for TV and cable distribution?
Answer: (B) 75 Ω
50 Ω coax is used for radio transmitters and test equipment.
What does VSWR indicate in a transmission line?
Answer: (A) The degree of impedance mismatch between line and load
A VSWR of 1 means a perfect match.
What is a repeater in communication systems?
Answer: (C) A device that receives, amplifies or regenerates and retransmits signals to extend range
Digital repeaters regenerate clean signals.
What is the main use of radar?
Answer: (A) Detecting and locating objects by transmitting radio waves and receiving reflections
Range is found from the echo time delay.
Which mobile generation introduced all-IP broadband using OFDMA (LTE)?
Answer: (D) 4G
5G adds higher speeds, lower latency and massive connectivity.
What is the main advantage of microwave links for long-distance telephone and data transmission?
Answer: (B) High bandwidth without cables, using line-of-sight towers
Towers are spaced about 40–50 km apart depending on terrain.
What is the uplink and downlink frequency band arrangement of C-band satellite systems approximately?
Answer: (C) Uplink about 6 GHz and downlink about 4 GHz
Ku-band uses about 14/12 GHz.
What is the main advantage of optical fibre over copper cable?
Answer: (A) Very high bandwidth, low loss and immunity to electromagnetic interference
Fibre forms the backbone of modern networks.
What is ground wave propagation mainly used for?
Answer: (C) Medium-wave and low-frequency broadcasting along the earth's surface
Ground waves follow the earth's curvature.
What is the main function of a duplexer in a radio transceiver?
Answer: (B) To allow transmitter and receiver to share one antenna
It isolates the receiver from transmitter power.
What is the effective isotropic radiated power (EIRP)?
Answer: (C) Transmitter power multiplied by antenna gain
EIRP is used in satellite link budgets.
What is the free-space path loss dependence on distance?
Answer: (A) It increases with the square of distance
In dB it rises by 6 dB per doubling of distance.
What is the main use of VSAT terminals?
Answer: (B) Small-dish satellite links for data and voice in remote areas
VSATs serve banks, schools and remote sites in Pakistan.
What is the main advantage of 5G over 4G networks?
Answer: (D) Higher data rates, lower latency and support for many more connected devices
5G uses wider bands including millimetre waves.
What is the purpose of the cladding in an optical fibre?
Answer: (C) To have a lower refractive index than the core so that light is guided by total internal reflection
A protective buffer surrounds the cladding.