Engineering, Management, Agriculture and Veterinary MCQs are now live. FPSC, PPSC, EPE, IELTS & GRE coming soon.
Question 1
Why is modulation needed in radio communication?
- To reduce bandwidth to zero
- To increase noise
- To shift signals to high frequencies for practical antenna sizes and to allow many signals to share the medium
- To remove the need for receivers
Show answer & solution
Answer: (C) To shift signals to high frequencies for practical antenna sizes and to allow many signals to share the medium
Low-frequency audio would need impractically long antennas.
Question 2
In amplitude modulation (AM), which carrier property varies with the message signal?
- Amplitude
- Polarisation
- Phase only
- Frequency
Show answer & solution
Answer: (A) Amplitude
The envelope follows the message.
Question 3
In frequency modulation, which carrier property changes according to the message signal?
- Polarisation
- Frequency
- Power
- Phase only
Show answer & solution
Answer: (B) Frequency
The amplitude stays constant in FM.
Question 4
How is the modulation index of AM defined?
- The sideband power
- The bandwidth
- The ratio of carrier to message frequency
- The ratio of message amplitude to carrier amplitude
Show answer & solution
Answer: (D) The ratio of message amplitude to carrier amplitude
Question 5
What happens when the AM modulation index exceeds 1?
- Bandwidth becomes zero
- The signal becomes FM
- Overmodulation causes envelope distortion
- Power falls to zero
Show answer & solution
Answer: (C) Overmodulation causes envelope distortion
Envelope detectors cannot recover the message correctly.
Question 6
What is the bandwidth of a conventional AM signal with a highest message frequency fm?
- fm/2
- fm
- 4fm
- 2fm
Show answer & solution
Answer: (D) 2fm
AM has upper and lower sidebands.
Question 7
What is the total power of an AM signal with carrier power Pc and modulation index m?
- Pc/2
- Pc(1 + m)
- Pc(1 + m²/2)
- Pc × m²
Show answer & solution
Answer: (C) Pc(1 + m²/2)
Most of the power remains in the carrier.
Question 8
What is the total transmitted power of an AM signal with 100% modulation and a carrier power of 10 kW?
- 10 kW
- 12.5 kW
- 15 kW
- 20 kW
Show answer & solution
Answer: (C) 15 kW
Pt = 10(1 + 1/2) = 15 kW.
Question 9
What fraction of the total power is carried by the sidebands in AM with 100% modulation?
- About one-third
- About two-thirds
- All of it
- About half
Show answer & solution
Answer: (A) About one-third
Sideband power is m²/2 of carrier power.
Question 10
What is DSB-SC modulation?
- Pulse modulation
- Double sideband with suppressed carrier, saving the power wasted in the carrier
- Frequency modulation
- Single sideband with full carrier
Show answer & solution
Answer: (B) Double sideband with suppressed carrier, saving the power wasted in the carrier
It needs coherent detection.
Question 11
What is the main advantage of single sideband (SSB) transmission?
- It carries no information
- It needs half the bandwidth and less power than conventional AM
- It needs more bandwidth
- It is easier to detect with envelope detectors
Show answer & solution
Answer: (B) It needs half the bandwidth and less power than conventional AM
SSB is used in HF communication.
Question 12
Which modulation was traditionally used for the picture signal in analog television broadcasting?
- FM
- SSB only
- PCM
- Vestigial sideband (VSB) AM
Show answer & solution
Answer: (D) Vestigial sideband (VSB) AM
VSB saves bandwidth while keeping simple detection.
Question 13
What is the modulation index of FM?
- The ratio of peak frequency deviation to the message frequency
- The ratio of amplitudes
- The carrier frequency
- The bandwidth
Show answer & solution
Answer: (A) The ratio of peak frequency deviation to the message frequency
Question 14
What does Carson's rule give for FM bandwidth?
- BW = Δf only
- BW = fm/2
- BW = 2fm
- BW ≈ 2(Δf + fm)
Show answer & solution
Answer: (D) BW ≈ 2(Δf + fm)
It contains about 98% of the signal power.
Question 15
What is the approximate bandwidth of an FM signal with 75 kHz deviation and a 15 kHz message?
- 30 kHz
- 90 kHz
- 150 kHz
- 180 kHz
Show answer & solution
Answer: (D) 180 kHz
BW = 2(75 + 15) = 180 kHz.
Question 16
What is the frequency range of FM broadcast radio in Pakistan?
- 1 to 2 GHz
- 3 to 30 MHz
- 88 to 108 MHz
- 530 to 1,600 kHz
Show answer & solution
Answer: (C) 88 to 108 MHz
FM channels such as Radio Pakistan FM 101 use this band.
Question 17
What is the main advantage of FM over AM?
- Better noise immunity and audio quality
- Less bandwidth
- Lower frequency
- Simpler transmitters always
Show answer & solution
Answer: (A) Better noise immunity and audio quality
Noise mostly affects amplitude, which FM receivers limit.
Question 18
What is the purpose of pre-emphasis and de-emphasis in FM?
- To reduce carrier power
- To improve signal-to-noise ratio at high audio frequencies
- To change carrier frequency
- To increase bandwidth
Show answer & solution
Answer: (B) To improve signal-to-noise ratio at high audio frequencies
High frequencies are boosted at the transmitter and cut at the receiver.
Question 19
What is the standard intermediate frequency (IF) of AM superheterodyne receivers?
- 1 GHz
- 10.7 MHz
- 50 Hz
- 455 kHz
Show answer & solution
Answer: (D) 455 kHz
FM receivers commonly use 10.7 MHz.
Question 20
What is the image frequency of a superheterodyne receiver tuned to fs with intermediate frequency IF and a local oscillator above the signal?
- fs − IF
- fs + 2IF
- fs + IF
- 2fs
Show answer & solution
Answer: (B) fs + 2IF
The RF stage must reject the image frequency.
Question 21
Which simple circuit demodulates conventional AM signals?
- PLL only
- Frequency discriminator
- Envelope detector using a diode and RC filter
- Product detector only
Show answer & solution
Answer: (C) Envelope detector using a diode and RC filter
DSB-SC and SSB need coherent detection.
Question 22
In phase modulation (PM), which carrier property varies with the message?
- Phase
- Amplitude
- Power
- Polarisation
Show answer & solution
Answer: (A) Phase
PM and FM are closely related forms of angle modulation.
Question 23
What is the frequency range of medium-wave AM broadcasting?
- About 3 to 30 GHz
- About 50 Hz
- About 88 to 108 MHz
- About 530 to 1,600 kHz
Show answer & solution
Answer: (D) About 530 to 1,600 kHz
Medium-wave signals travel by ground wave and at night by sky wave.
Question 24
What is the main advantage of the superheterodyne receiver?
- It needs no local oscillator
- It works without tuning
- Most amplification and selectivity occur at a fixed intermediate frequency
- It has no image problem
Show answer & solution
Answer: (C) Most amplification and selectivity occur at a fixed intermediate frequency
It is the standard receiver architecture.
Question 25
What is the bandwidth of an SSB signal with a 4 kHz message?
- 2 kHz
- 4 kHz
- 8 kHz
- 16 kHz
Show answer & solution
Answer: (B) 4 kHz
Only one sideband is transmitted.
Question 26
What is a product detector used for?
- Envelope detection only
- Power measurement
- FM demodulation only
- Coherent demodulation of DSB-SC and SSB signals
Show answer & solution
Answer: (D) Coherent demodulation of DSB-SC and SSB signals
It multiplies the signal with a locally generated carrier.
Question 27
- AM with large index
- FM with very large deviation
- A digital code
- FM with a small modulation index, giving a bandwidth close to that of AM
Show answer & solution
Answer: (D) FM with a small modulation index, giving a bandwidth close to that of AM
Wideband FM is used for broadcasting.
Question 28
What is the maximum frequency deviation allowed in commercial FM broadcasting?
- 1 MHz
- 5 kHz
- 75 kHz
- 200 kHz
Show answer & solution
Answer: (C) 75 kHz
Channels are spaced about 200 kHz apart.
Question 29
What is the modulation index of an FM signal with a frequency deviation of 50 kHz and a message frequency of 10 kHz?
- 0.2
- 5
- 50
- 500
Show answer & solution
Answer: (B) 5
Question 30
What device is used to demodulate FM in modern receivers?
- Phase-locked loop or quadrature detector
- Diode clamper
- Product detector only
- Envelope detector
Show answer & solution
Answer: (A) Phase-locked loop or quadrature detector
Older receivers used Foster–Seeley discriminators.