reduce the dissolved calcium and magnesium salts that cause hardness
remove suspended particles and colloids that cause turbidity, as coagulation and sedimentation do
remove dissolved gases such as hydrogen sulphide
Show answer & solution
Answer: (B) reduce the dissolved calcium and magnesium salts that cause hardness
Hardness is due to Ca2+ and Mg2+; softening removes or reduces them (lime-soda, ion exchange).
Question 2
Defluoridation is practised in areas where the natural groundwater contains
excess chloride, which makes the water taste salty
excess fluoride, which must be reduced to avoid dental and skeletal fluorosis
excess calcium and magnesium, which cause scaling
too little fluoride, which must be made up by dosing the water before it is supplied
Show answer & solution
Answer: (B) excess fluoride, which must be reduced to avoid dental and skeletal fluorosis
Water above the WHO guideline of 1.5 mg/L fluoride causes fluorosis; defluoridation (e.g. activated alumina, bone char) lowers it.
Question 3
Excess dissolved iron and manganese in groundwater are generally removed by
chlorination alone, since the dissolved metals never form any solids that need removal
aeration to oxidize them, followed by sedimentation and filtration of the precipitate
UV irradiation, which precipitates the metals from solution
lime-soda softening, which converts them into soluble salts
Show answer & solution
Answer: (B) aeration to oxidize them, followed by sedimentation and filtration of the precipitate
Soluble Fe2+/Mn2+ are oxidized (by aeration, often with chlorine or permanganate) to insoluble Fe(OH)3/MnO2, which are then settled and filtered.
Question 4
Ozone and ultraviolet (UV) disinfection differ from chlorination in that they
leave a longer-lasting residual than free chlorine, which is why they are preferred for long networks
leave a combined residual similar to chloramines
leave no persistent disinfectant residual in the treated water
are unable to inactivate bacteria and viruses
Show answer & solution
Answer: (C) leave no persistent disinfectant residual in the treated water
Ozone decays rapidly and UV is purely physical, so neither gives residual protection in the distribution system; a secondary chlorine dose is usually added.
Question 5
Coagulation involves adding a chemical such as alum mainly to
remove dissolved gases such as hydrogen sulphide from the water
kill pathogenic bacteria by lowering the pH of the water
destabilise fine colloids so that they can aggregate
raise the dissolved oxygen so that organic matter is oxidised
Show answer & solution
Answer: (C) destabilise fine colloids so that they can aggregate
Coagulants neutralise the charge on colloids, allowing them to form flocs.
Question 6
Which sequence correctly represents a conventional surface water treatment plant?
The order follows removal of coarse to fine impurities, with disinfection last.
Question 7
Sedimentation in water treatment relies mainly on
ultraviolet inactivation of microbes
centrifugal separation of particles
adsorption of impurities on activated carbon in normal practice
gravity settling of flocs in a settling tank
Show answer & solution
Answer: (D) gravity settling of flocs in a settling tank
Flocs heavier than water settle by gravity under quiescent conditions in the tank.
Question 8
The basic objective of water treatment is to
lower the temperature of the raw water to suit consumer demand
treat industrial wastewater before it is reused in factories
make raw water safe, wholesome and acceptable for drinking use
add minerals and fluoride to supplies for general health benefit
Show answer & solution
Answer: (C) make raw water safe, wholesome and acceptable for drinking use
Treatment removes harmful and objectionable constituents to meet drinking water standards.
Question 9
Why does a conventional surface water treatment plant combine several unit processes in sequence rather than relying on a single step?
Different contaminants (turbidity, colour, pathogens) need different steps, applied in a suitable order
Disinfection alone removes turbidity and dissolved chemicals, so the earlier units are optional
Several units are used only to spread the cost, since one unit could achieve all removals in principle
Each unit removes the same impurities, giving a safety margin in case any one of them fails
Show answer & solution
Answer: (A) Different contaminants (turbidity, colour, pathogens) need different steps, applied in a suitable order
Typical sequence: screening, coagulation-flocculation, sedimentation, filtration, then disinfection; each step prepares water for the next.
Question 10
Disinfection in water treatment is used mainly to
remove hardness from the water
remove the remaining turbidity from the water
kill or inactivate pathogens remaining in the water
remove taste and colour from the water
Show answer & solution
Answer: (C) kill or inactivate pathogens remaining in the water
Disinfection is the final barrier against waterborne pathogens.
Question 11
Aeration in water treatment is used mainly to
remove dissolved gases such as CO₂ and H₂S and oxidise Fe and Mn
kill pathogens by exposure to air and sunlight
soften the water by precipitating hardness salts
remove turbidity by settling of fine particles
Show answer & solution
Answer: (A) remove dissolved gases such as CO₂ and H₂S and oxidise Fe and Mn
Aeration strips gases, reduces taste and odour and oxidises Fe²⁺ and Mn²⁺.
Question 12
Package (compact) water treatment plants are generally characterized by
being built only in-situ in large masonry basins
using only chlorination, with coagulation and filtration left out to reduce the unit cost
serving only cities of over one million people
combining several treatment processes in one factory-built unit for small communities
Show answer & solution
Answer: (D) combining several treatment processes in one factory-built unit for small communities
A package plant integrates flocculation, settling, filtration and disinfection in a prefabricated unit for small flows.
Question 13
Flocculation is the process of
removal of dissolved gases such as hydrogen sulphide and carbon dioxide by aeration of the water
chemical disinfection of the water using chlorine or ozone as the disinfectant
rapid mixing to disperse the coagulant throughout the water
slow, gentle mixing that lets destabilised particles form larger flocs
Show answer & solution
Answer: (D) slow, gentle mixing that lets destabilised particles form larger flocs
Slow mixing (velocity gradient about 20–75 s⁻¹) builds flocs without breaking them.
Question 14
Chlorination of drinking water involves adding
alum or ferric chloride as a coagulant to remove turbidity and colour
chlorine or a compound such as hypochlorite or bleaching powder
lime and soda ash as softening chemicals to precipitate hardness
powdered activated carbon as an adsorbent for taste and odour
Show answer & solution
Answer: (B) chlorine or a compound such as hypochlorite or bleaching powder
Chlorine in sufficient dose leaves a residual (commonly about 0.2–0.5 mg/L) to disinfect water.
Question 15
A rapid sand filter operates at
a lower filtration rate than a slow sand filter does
a much higher rate than a slow sand filter and needs pre-treatment
a rate controlled by a biological layer on the sand
the same filtration rate as a slow sand filter does
Show answer & solution
Answer: (B) a much higher rate than a slow sand filter and needs pre-treatment
Rapid sand filters run at about 3–6 m/h, i.e. 15–30 times faster than slow sand filters.
Question 16
Filtration after sedimentation is used mainly to
remove remaining fine particles and flocs through a granular bed
remove dissolved gases from the settled water
soften the water by removing calcium and magnesium
kill all pathogens present in the settled water
Show answer & solution
Answer: (A) remove remaining fine particles and flocs through a granular bed
Filters remove the turbidity left after sedimentation, preparing water for disinfection.
Question 17
Routine water quality monitoring at a treatment plant is carried out mainly to
avoid the need for coagulation and disinfection, because tested water is automatically safe
determine the population to be served by the plant
verify that treatment works and finished water meets drinking-water quality standards
fix the price charged per unit of water supplied
Show answer & solution
Answer: (C) verify that treatment works and finished water meets drinking-water quality standards
Monitoring (turbidity, residual chlorine, microbiology) confirms performance and compliance with guidelines such as the WHO / Pak-EPA drinking water standards.
Question 18
The detention time in a sedimentation tank is important mainly because
it must be short enough to prevent algae growth, whatever the settling velocity of the flocs
it must be long enough for flocs to settle before the water leaves
it affects only the sludge volume and does not influence settling of flocs
a shorter detention time gives better removal because the flocs break up less
Show answer & solution
Answer: (B) it must be long enough for flocs to settle before the water leaves
Detention time = volume/flow; adequate time (typically 2–4 hours) is needed for settling.
Question 19
Residual chlorine is maintained at a small concentration in a distribution system mainly to
softening of the water by precipitating hardness salts as it stands in the distribution mains
continued protection against microbial recontamination as water moves through the network
eliminate the need for disinfection at the treatment plant
remove turbidity from water standing in service reservoirs
Show answer & solution
Answer: (B) continued protection against microbial recontamination as water moves through the network
A free chlorine residual (about 0.2-0.5 mg/L at the consumer end, in line with WHO guidance) guards against recontamination in the network.
Question 20
Chlorine demand of a water sample is best defined as
the chlorine dose needed to give a fixed 0.5 mg/L residual in any water
the free chlorine concentration that remains in the water after the specified contact period is over
the chlorine consumed by organic matter and reducing agents before free residual chlorine appears
the chlorine lost to evaporation from an open storage tank
Show answer & solution
Answer: (C) the chlorine consumed by organic matter and reducing agents before free residual chlorine appears
Chlorine demand = dose applied minus residual remaining after a specified contact time; it is the chlorine consumed by oxidizable substances.
Question 21
A slow sand filter operates at
a low filtration rate and relies on the schmutzdecke for purification
a high filtration rate and relies on prior chemical coagulation
a high filtration rate and relies on regular backwashing of the bed
a low filtration rate and relies on prior coagulation and regular backwashing
Show answer & solution
Answer: (A) a low filtration rate and relies on the schmutzdecke for purification
Slow sand filters run at about 0.1–0.4 m/h, with biological action in the schmutzdecke.
Question 22
The ion-exchange (zeolite) process softens water mainly by
exchanging calcium and magnesium ions for sodium ions held on the exchange resin
killing the hardness-causing bacteria with an oxidant
precipitating calcium and magnesium as carbonates and hydroxides, as in the lime-soda process