What is the relation between the standard Gibbs energy change and the equilibrium constant?
Show answer & solution
Answer: (A) ΔG° = −RT ln K
A large K means a negative ΔG°.
Chemical Engineering · Chemical Engineering Thermodynamics
34 questions, each with the answer and a worked solution.
Practice interactively and track your score →What is the relation between the standard Gibbs energy change and the equilibrium constant?
Answer: (A) ΔG° = −RT ln K
A large K means a negative ΔG°.
What is the equilibrium constant when ΔG° = 0?
Answer: (D) 1
ln K = 0.
What does the van 't Hoff equation describe?
Answer: (C) The effect of temperature on the equilibrium constant
d ln K/dT = ΔH°/(RT²).
How does temperature affect K for an exothermic reaction?
Answer: (B) K decreases as temperature increases
Ammonia synthesis is exothermic.
How does temperature affect K for an endothermic reaction?
Answer: (D) K increases as temperature increases
Steam reforming of methane is endothermic and favoured at high temperature.
What does Le Chatelier's principle state?
Answer: (A) A system at equilibrium shifts to counteract an imposed change
It predicts effects of pressure, temperature and concentration.
How does increasing pressure affect the ammonia synthesis equilibrium N₂ + 3H₂ ⇌ 2NH₃?
Answer: (C) It shifts equilibrium toward ammonia
Total moles decrease from 4 to 2.
Why is ammonia synthesis carried out at about 400–500 °C despite being favoured by low temperature?
Answer: (C) To obtain an acceptable reaction rate with the iron catalyst
It is a compromise between rate and equilibrium.
How does adding an inert gas at constant total pressure affect a gas reaction with a decrease in moles?
Answer: (A) It shifts equilibrium toward the side with more moles (reactants)
Inerts act like lowering partial pressures.
Does a catalyst change the equilibrium constant?
Answer: (B) No, it only increases the rate of reaching equilibrium
It lowers activation energy for forward and reverse reactions equally.
What is the effect of pressure on Kp for an ideal-gas reaction?
Answer: (D) Kp does not depend on pressure
Pressure changes equilibrium composition but not K.
How is Kp related to Kc for ideal gases?
Answer: (A) Kp = Kc(RT)^Δn
Δn is the change in moles of gas.
What is the reaction coordinate (extent of reaction) used for in equilibrium calculations?
Answer: (C) Expressing all mole numbers in terms of one variable
ni = ni0 + νi ε.
What is the standard state for a gas in reaction equilibrium?
Answer: (D) Pure ideal gas at 1 bar and the system temperature
Standard states must be stated for each species.
What does a very large equilibrium constant indicate?
Answer: (B) The reaction lies far toward products
K says nothing about the rate.
What is the standard Gibbs energy of formation of an element in its standard state?
Answer: (A) Zero
ΔG°rxn = Σ ΔG°f(products) − Σ ΔG°f(reactants).
Why is the water–gas shift reaction CO + H₂O ⇌ CO₂ + H₂ carried out in two stages (high and low temperature)?
Answer: (B) It is exothermic, so low temperature favours conversion while high temperature gives fast rate
Ammonia plants use HTS and LTS converters.
How does pressure affect the water–gas shift equilibrium?
Answer: (C) It has almost no effect since moles of gas do not change
Δn = 0.
What is the equilibrium constant at 298 K for a reaction with ΔG° = −5.7 kJ/mol?
Answer: (C) About 10
ln K = 5,700/(8.314 × 298) = 2.30.
What is the condition for chemical equilibrium in a reacting system?
Answer: (D) Σ νi μi = 0
It means the Gibbs energy is at a minimum.
How does increasing steam-to-carbon ratio affect methane steam reforming?
Answer: (D) It increases methane conversion and reduces carbon formation
Excess steam shifts equilibrium toward products.
What is the equilibrium constant expression Kp for N₂ + 3H₂ ⇌ 2NH₃?
Answer: (A) p²NH₃/(pN₂ p³H₂)
Partial pressures are raised to stoichiometric powers.
What is the effect of removing a product continuously from an equilibrium reaction?
Answer: (C) It drives the reaction forward to form more product
Reactive distillation uses this principle.
How does temperature affect ΔG° of a reaction?
Answer: (D) Through ΔG° = ΔH° − TΔS°
Reactions with positive ΔS° become more favourable at higher temperature.
Above what temperature does a reaction with ΔH° = 100 kJ/mol and ΔS° = 0.2 kJ/(mol·K) become spontaneous under standard conditions?
Answer: (C) 500 K
T = ΔH°/ΔS°, assuming constant values.
What is the equilibrium conversion when the equilibrium constant is extremely small?
Answer: (A) Very low conversion
The reverse reaction dominates.
Why is SO₂ oxidation to SO₃ in sulphuric acid plants done in several catalyst beds with intercooling?
Answer: (D) The reaction is exothermic, so cooling between beds raises equilibrium conversion
Vanadium pentoxide catalyst is used.
What is the effect of increasing temperature on equilibrium conversion of SO₂ to SO₃?
Answer: (B) It decreases equilibrium conversion
The reaction releases heat.
What is the effect of pressure on the reaction CaCO₃(s) ⇌ CaO(s) + CO₂(g)?
Answer: (C) Lower CO₂ pressure favours decomposition
Kp equals the equilibrium CO₂ partial pressure.
What is the equilibrium constant expression for CaCO₃(s) ⇌ CaO(s) + CO₂(g)?
Answer: (B) Kp = pCO₂
Activities of pure solids are taken as 1.
What is the equilibrium constant for a reaction written in reverse?
Answer: (A) The reciprocal of the forward K
Doubling all coefficients squares K.
For multiple reactions, what is the equilibrium constant of a reaction obtained by adding two reactions?
Answer: (D) The product of their equilibrium constants
ΔG° values add, so K values multiply.
What is the degree of freedom for a reacting system with C species, P phases and r independent reactions?
Answer: (C) F = C − P + 2 − r
Each independent reaction adds an equilibrium constraint.
What does ΔG° = 0 at a certain temperature imply about the reaction at that temperature?
Answer: (B) K = 1 and reactants and products are equally favoured under standard conditions
It marks the crossover temperature.