What is the uncontrolled spreading of water over the whole field without bunds called?
Show answer & solution
Answer: (B) Wild flooding
It wastes water and gives uneven application.
Agriculture · Irrigation & Water Management
46 questions, each with the answer and a worked solution.
Practice interactively and track your score →What is the uncontrolled spreading of water over the whole field without bunds called?
Answer: (B) Wild flooding
It wastes water and gives uneven application.
Which irrigation method, in which water is applied to a ring around each tree, is suitable for orchards?
Answer: (B) Ring (basin) method
It saves water and keeps the trunk dry.
Which method divides a field into small level plots surrounded by bunds and fills them with water?
Answer: (C) Check-basin method
It is common for wheat in Pakistan.
Which irrigation method applies water through narrow channels between crop rows?
Answer: (C) Furrow irrigation
Furrows are used for cotton, maize, sugarcane and vegetables.
What is applying water below the soil surface, raising the water table or through buried pipes, called?
Answer: (B) Sub-surface irrigation
It reduces evaporation losses.
What type of irrigation system sprays water like rain through nozzles under pressure?
Answer: (B) Sprinkler irrigation
Sprinklers suit uneven land and sandy soils.
Which large sprinkler system rotates around a central pivot to irrigate a circular field?
Answer: (A) Centre pivot system
Centre pivots are used on large farms.
What are the small devices in drip systems that release water slowly at fixed rates called?
Answer: (B) Emitters (drippers)
Clogging of emitters is a common problem.
Why is a filter an essential part of a drip irrigation system?
Answer: (A) To prevent clogging of emitters
Sand, screen and disc filters are used.
Which device is used to inject fertilizer into drip systems?
Answer: (B) Venturi injector or fertilizer tank
Applying fertilizer through drip is called fertigation.
Why is drip irrigation not commonly used for closely spaced crops like wheat?
Answer: (A) High cost of laterals and emitters
It is economical for orchards, vegetables and widely spaced crops.
What are drip and sprinkler systems together commonly called in Pakistan's water projects?
Answer: (B) High efficiency irrigation systems (HEIS)
The government subsidizes HEIS to save water.
What is the ratio of water delivered to the fields to water diverted at the source called?
Answer: (A) Conveyance efficiency
Seepage in canals and watercourses lowers conveyance efficiency.
What is the ratio of water stored in the root zone to water delivered to the field called?
Answer: (A) Water application efficiency
Runoff and deep percolation lower application efficiency.
What is the ratio of water stored in the root zone to the water needed to fill it to field capacity called?
Answer: (A) Water storage efficiency
It shows whether irrigation adequately refilled the root zone.
What does the Christiansen uniformity coefficient measure?
Answer: (C) Uniformity of water distribution, especially in sprinkler systems
A high value means water is spread evenly.
Approximately what is the typical water application efficiency of drip irrigation?
Answer: (A) About 90%
Surface methods often achieve only 40–60%.
Why do long, unlined watercourses in Pakistan lose much water?
Answer: (D) Seepage and leakage along the way
Studies show large losses between the outlet and the field.
What is the Punjab programme that lines watercourses, levels fields and promotes efficient irrigation called?
Answer: (D) On-Farm Water Management (OFWM)
OFWM works with water user associations.
What are groups of farmers organized to manage and maintain watercourses called?
Answer: (A) Water user associations
Farmers share labour and costs of improving watercourses.
Which field shape generally gives higher water application efficiency?
Answer: (A) Rectangular, levelled plots
Levelled plots let water spread evenly.
What is the main benefit of laser-levelled fields for irrigation?
Answer: (D) Uniform water distribution and less water use
Precise levelling saves irrigation water.
Which water-saving practice for rice keeps fields alternately flooded and dried?
Answer: (A) Alternate wetting and drying (AWD)
AWD saves water without major yield loss.
What is deficit irrigation?
Answer: (D) Deliberately applying less water than full crop requirement at less sensitive stages
It increases water productivity where water is scarce.
What does irrigation at the right time, in the right amount, based on crop needs ensure?
Answer: (D) Higher water productivity and yield
Over-irrigation wastes water and leaches nutrients.
What is the water required to raise a crop including evapotranspiration and unavoidable losses called?
Answer: (B) Crop water requirement (irrigation requirement)
It is met by rainfall, irrigation and soil moisture.
What is net irrigation requirement plus field losses called?
Answer: (C) Field irrigation requirement
Conveyance losses are added to get the gross requirement.
What is the portion of available soil moisture that can be used before irrigation is needed, without stressing the crop, called?
Answer: (C) Management allowed depletion (MAD)
It is usually about 50% for many crops.
Approximately what is the total water requirement of rice?
Answer: (A) About 120–150 cm
Rice uses much more water than wheat.
Approximately what is the total water requirement of sugarcane?
Answer: (B) About 150–250 cm
It stays in the field for about a year.
What is the main reason for higher water use of rice compared with wheat?
Answer: (B) Flooding, percolation and high evapotranspiration in summer
Direct seeding and AWD reduce rice water use.
Which type of crops can make better use of stored soil moisture with fewer irrigations?
Answer: (B) Deep-rooted crops
Onion and vegetables are shallow-rooted and need frequent light irrigation.
What is the cost-saving combined use of canal water and groundwater for irrigation called?
Answer: (C) Conjunctive use
Mixing canal water with marginal groundwater improves its quality.
What is mixing saline groundwater with fresh canal water in a fixed ratio for irrigation sometimes called?
Answer: (B) Blending (amalgamation)
Blending makes marginal groundwater usable.
What is the removal of salts from water by membrane processes such as reverse osmosis called?
Answer: (C) Desalination
It is costly for irrigation but useful for drinking water.
Why is mulching useful in irrigated agriculture?
Answer: (D) It reduces evaporation from the soil surface
Organic and plastic mulches conserve soil moisture.
Which sprinkler system is moved by hand from one position to another?
Answer: (B) Portable (hand-move) sprinkler system
It has low initial cost but high labour needs.
Why is sprinkler irrigation less efficient in windy, hot conditions?
Answer: (D) Wind drift and evaporation losses increase
Irrigating in calm hours improves uniformity.
What is the main advantage of furrow irrigation compared with flooding?
Answer: (C) Less water wetting the soil surface and less crusting
Water reaches roots from the side of the ridge.
What is applying irrigation water to every other furrow called?
Answer: (B) Alternate furrow irrigation
It saves water with little yield loss in many crops.
What is the time from start to end of irrigation application at a point in a furrow, which determines infiltrated depth, called?
Answer: (C) Intake opportunity time
Longer opportunity time means deeper infiltration.
What is the problem when water is applied too long at the head end of a long furrow or border?
Answer: (A) Deep percolation losses at the head
Shorter runs and proper stream size reduce losses.
Which method of irrigation scheduling is based on measuring soil moisture?
Answer: (A) Soil moisture–based scheduling with tensiometers or sensors
It ensures water is applied when actually needed.
Which crop growth stage of wheat is most sensitive to water stress?
Answer: (C) Crown root initiation and flowering stages
Missing irrigation at critical stages reduces yield sharply.
Which irrigation system is most suitable for orchards in water-scarce areas of Balochistan?
Answer: (D) Drip irrigation
Drip saves water in apple, grape and date orchards.
What is the main constraint to adoption of drip and sprinkler systems by small farmers in Pakistan?
Answer: (D) High initial cost and maintenance needs
Subsidy programmes aim to address the cost barrier.