What is the composition of dry air commonly assumed in combustion calculations (by moles)?
Show answer & solution
Answer: (A) 21% oxygen and 79% nitrogen
Each mole of O₂ is accompanied by 79/21 = 3.76 moles of N₂.
Chemical Engineering · Stoichiometry
33 questions, each with the answer and a worked solution.
Practice interactively and track your score →What is the composition of dry air commonly assumed in combustion calculations (by moles)?
Answer: (A) 21% oxygen and 79% nitrogen
Each mole of O₂ is accompanied by 79/21 = 3.76 moles of N₂.
How many moles of air supply 1 mole of oxygen?
Answer: (C) About 4.76
1/0.21 = 4.76.
How many moles of theoretical air are required to burn 1 mole of methane completely?
Answer: (D) About 9.52
CH₄ + 2O₂ → CO₂ + 2H₂O; 2 × 4.76 = 9.52.
How many moles of air are supplied per mole of methane with 20% excess air?
Answer: (D) About 11.43
9.52 × 1.2 = 11.42.
What mass of oxygen is needed to burn 12 kg of carbon completely to CO₂?
Answer: (C) 32 kg
C + O₂ → CO₂.
What does Orsat analysis of flue gas measure?
Answer: (B) The volume percentages of CO₂, O₂ and CO on a dry basis, with N₂ by difference
Water vapour is condensed before analysis.
Which reagent absorbs CO₂ in the Orsat apparatus?
Answer: (A) Potassium hydroxide solution
Alkaline pyrogallol absorbs O₂ and ammoniacal cuprous chloride absorbs CO.
What does the proximate analysis of coal determine?
Answer: (B) Moisture, volatile matter, ash and fixed carbon
Ultimate analysis gives the elemental composition.
Which instrument measures the calorific value of gaseous fuels?
Answer: (D) Junkers gas calorimeter
A bomb calorimeter is used for solid and liquid fuels.
What does Dulong's formula estimate?
Answer: (B) The calorific value of a fuel from its ultimate analysis
HCV ≈ 33.8C + 144(H − O/8) + 9.4S MJ/kg, with mass fractions.
What gas is mainly produced by incomplete combustion of carbon?
Answer: (C) Carbon monoxide
CO is toxic and represents wasted fuel energy.
Why is too much excess air undesirable in furnaces and boilers?
Answer: (A) It increases heat lost in hot flue gas and lowers efficiency
Too little air causes incomplete combustion.
What is the main constituent of natural gas from fields such as Sui?
Answer: (C) Methane
Sui gas also contains some CO₂ and nitrogen.
What are the main components of LPG?
Answer: (A) Propane and butane
LPG is liquefied under moderate pressure.
What is water gas?
Answer: (B) A mixture mainly of carbon monoxide and hydrogen made by passing steam over hot coke
C + H₂O → CO + H₂.
What is producer gas mainly composed of?
Answer: (D) Carbon monoxide and nitrogen
It is made by passing air (and some steam) over hot coke.
What does the octane number of petrol indicate?
Answer: (C) Its resistance to knocking in spark-ignition engines
Isooctane is rated 100 and n-heptane 0.
What does the cetane number of diesel fuel indicate?
Answer: (A) Its ignition quality in compression-ignition engines
A higher cetane number means shorter ignition delay.
What is the flash point of a fuel?
Answer: (D) The lowest temperature at which its vapour ignites momentarily when a flame is applied
The fire point is the temperature of sustained burning.
What is the main environmental concern from sulphur in fuels?
Answer: (B) Formation of SO₂, which causes acid rain and air pollution
Low-sulphur fuels and flue gas desulphurisation reduce emissions.
What is the approximate stoichiometric air–fuel ratio by mass for petrol?
Answer: (C) About 14.7:1
Engines with catalytic converters run close to this ratio.
Which rank of coal has the highest carbon content and calorific value?
Answer: (D) Anthracite
Thar coal is lignite, which has high moisture and low calorific value.
What is the stoichiometric oxygen required to burn 1 kmol of propane (C₃H₈)?
Answer: (C) 5 kmol
C₃H₈ + 5O₂ → 3CO₂ + 4H₂O.
What is coke oven gas?
Answer: (A) A gas rich in hydrogen and methane produced during carbonisation of coal
It is a valuable fuel in steel plants.
What is the main source of aromatic compounds such as benzene, toluene and xylene from coal?
Answer: (B) Coal tar from high-temperature carbonisation
Today most aromatics come from petroleum reforming.
Why is the net calorific value used in boiler efficiency calculations in many countries?
Answer: (A) Water vapour in flue gas usually leaves uncondensed, so its latent heat is not recovered
Condensing boilers can recover part of the latent heat.
What is the main product of burning hydrogen in air?
Answer: (B) Water vapour
2H₂ + O₂ → 2H₂O; hydrogen fuel releases no CO₂ at the point of use.
How many kilograms of oxygen are needed to burn 1 kg of hydrogen completely?
Answer: (B) 8 kg
2H₂ + O₂ → 2H₂O; 4 kg H₂ needs 32 kg O₂.
What is compressed natural gas (CNG) stored at, approximately, in vehicle cylinders?
Answer: (C) About 200 to 250 bar
CNG was widely used in Pakistani vehicles.
What does a high percentage of CO in flue gas indicate?
Answer: (A) Incomplete combustion due to insufficient air or poor mixing
CO should be kept very low for efficiency and safety.
What does a high percentage of O₂ in flue gas indicate?
Answer: (D) Excessive excess air
Flue gas O₂ analysers are used to trim combustion air.
What is the volatile matter of coal?
Answer: (A) The portion released as gas and vapour when coal is heated in the absence of air
High volatile coals ignite easily.
How is fixed carbon found in proximate analysis?
Answer: (A) By subtracting moisture, volatile matter and ash percentages from 100
It is the solid combustible residue after volatile matter is driven off.