What are the main primary air pollutants from combustion?
Show answer & solution
Answer: (D) Particulate matter, sulphur dioxide, nitrogen oxides, carbon monoxide and hydrocarbons
Secondary pollutants form in the atmosphere.
Chemical Engineering · Environmental Engineering
40 questions, each with the answer and a worked solution.
Practice interactively and track your score →What are the main primary air pollutants from combustion?
Answer: (D) Particulate matter, sulphur dioxide, nitrogen oxides, carbon monoxide and hydrocarbons
Secondary pollutants form in the atmosphere.
Which is a secondary air pollutant?
Answer: (B) Ground-level ozone
It forms from NOx and VOCs in sunlight.
What is PM2.5?
Answer: (A) Particulate matter with aerodynamic diameter of 2.5 µm or less
It penetrates deep into the lungs and is linked to heart and lung disease.
What is the WHO 2021 guideline for annual mean PM2.5?
Answer: (B) 5 µg/m³
Lahore and other Pakistani cities often far exceed it.
What is photochemical smog?
Answer: (C) A mixture of ozone and other oxidants formed when NOx and VOCs react in sunlight
It causes eye irritation and breathing problems.
What are the main causes of winter smog in Lahore and other Punjab cities?
Answer: (D) Vehicle and industrial emissions, crop residue burning and stagnant cold air with temperature inversions
Inversions trap pollutants near the ground.
What is a temperature inversion?
Answer: (A) A layer where temperature increases with height, trapping pollutants below it
It suppresses vertical mixing.
What is the adiabatic lapse rate of dry air?
Answer: (C) About 9.8 °C per km
Atmospheric stability depends on the actual lapse rate.
When is the atmosphere considered unstable?
Answer: (A) When the environmental lapse rate exceeds the dry adiabatic lapse rate
Unstable conditions disperse pollutants well.
What is the Gaussian plume model used for?
Answer: (B) Estimating ground-level concentrations downwind of a stack
It uses dispersion coefficients based on stability classes.
How does increasing stack height affect ground-level concentration?
Answer: (D) It generally reduces the maximum ground-level concentration
Effective height includes plume rise.
What causes acid rain?
Answer: (C) SO₂ and NOx converting to sulphuric and nitric acids in the atmosphere
Normal rain has pH about 5.6 due to CO₂.
What is flue gas desulphurisation (FGD)?
Answer: (D) Removing SO₂ from flue gas, commonly by wet limestone scrubbing producing gypsum
It is fitted to coal power plants.
What is selective catalytic reduction (SCR)?
Answer: (A) Reducing NOx to nitrogen and water with ammonia or urea over a catalyst
It achieves high NOx removal.
What are low-NOx burners designed to do?
Answer: (B) Reduce flame peak temperature and oxygen availability to limit NOx formation
Staged air and fuel combustion are used.
What is thermal NOx?
Answer: (B) NOx formed from atmospheric nitrogen and oxygen at high flame temperatures
It increases sharply above about 1,500 °C.
What is the main function of a catalytic converter in a petrol car?
Answer: (D) Oxidising CO and hydrocarbons and reducing NOx
Three-way catalysts need unleaded fuel and controlled air–fuel ratio.
Which particulate control device has the highest collection efficiency for fine particles?
Answer: (A) Fabric (bag) filter
Bag filters and ESPs can exceed 99%.
What is the main advantage of an electrostatic precipitator?
Answer: (C) High efficiency with low pressure drop for large gas volumes
It is used in power and cement plants.
What is a wet scrubber used for?
Answer: (B) Removing particulates and soluble gases by contact with liquid
Venturi scrubbers capture fine particles.
What is adsorption on activated carbon used for in air pollution control?
Answer: (D) Removing VOCs and odours from gas streams
The carbon is regenerated or replaced.
What is thermal oxidation (incineration) of VOCs?
Answer: (C) Destroying VOCs by combustion at high temperature
Regenerative thermal oxidisers recover heat.
What is the main greenhouse gas from human activities?
Answer: (A) Carbon dioxide
Methane and nitrous oxide are also important.
What is global warming potential (GWP)?
Answer: (C) A measure of how much heat a gas traps relative to CO₂ over a given period
Methane has a 100-year GWP of about 28–30.
What depletes the stratospheric ozone layer?
Answer: (D) Chlorine and bromine from CFCs, halons and similar compounds
The Montreal Protocol controls these substances.
What is indoor air pollution from biomass cooking mainly a problem of?
Answer: (B) Smoke with particulates and CO in poorly ventilated kitchens
It affects many rural households.
What is the main source of lead in urban air before the phase-out of leaded petrol?
Answer: (A) Vehicle exhaust from leaded gasoline
Lead levels fell after unleaded petrol was introduced.
What does AQI stand for?
Answer: (D) Air Quality Index, a scale communicating pollution levels to the public
Higher values mean poorer air quality.
Which gas is colourless and odourless but binds to haemoglobin, reducing oxygen transport?
Answer: (A) Carbon monoxide
It is dangerous in enclosed spaces with gas heaters.
What is the main health effect of SO₂?
Answer: (D) Irritation of the respiratory tract and aggravation of asthma
It also forms sulphate particles.
Which pollutant gives the brown colour to polluted urban air?
Answer: (B) Nitrogen dioxide
NO₂ absorbs blue light.
What is the main purpose of continuous emission monitoring systems (CEMS)?
Answer: (C) Measuring pollutant concentrations in stack gas continuously for compliance
CEMS are fitted to power and cement plants.
What is isokinetic stack sampling?
Answer: (A) Sampling particulate matter at the same velocity as the stack gas to avoid bias
Unequal velocity misrepresents particle concentration.
What is the main air pollutant from brick kilns in Pakistan?
Answer: (B) Smoke and particulate matter from inefficient coal and waste burning
Zig-zag kiln technology reduces emissions.
What is zig-zag kiln technology in brick making?
Answer: (C) A kiln design with zig-zag air flow giving better combustion and lower emissions
Punjab encouraged conversion to cut smog.
What is the main pollutant from crop residue burning?
Answer: (D) Smoke with fine particulates and CO
Burning rice stubble contributes to winter smog.
What is noise measured in?
Answer: (D) Decibels (dB), often A-weighted
A 10 dB increase is about ten times the sound intensity.
What is the main purpose of a stack in air pollution control?
Answer: (A) Dispersing pollutants high into the atmosphere to reduce ground-level concentrations
It does not reduce total emissions.
What is the main greenhouse gas emitted from rice paddies and livestock?
Answer: (C) Methane
Livestock is a major source in Pakistan's agriculture.
What is nitrous oxide emitted from mainly in agriculture?
Answer: (B) Nitrogen fertiliser use in soils
It is a potent greenhouse gas.